2004 crown victoria lights dont work brake lights dont work turning light dont work

Is that when the light switch is turned on or when the brakes are applied? Please specify the condition and I will have a better idea of the problem?

If you are referring to when the headlight switch is on and the tail lights go off then you most likely have a bad headlamp switch or a bad connection between the tail lamps and the relay? If the brake lights are what you are referring to then your brake light switch on the brake pedal could be faulty? Please specify in detail what where when and which lights in reference? I can help a lot easier when you know these, Thank you!

change the light control module. it is located under the dash near your right knee on the drivers side. this is a common problem with crown vics.

Have you checked the brake light switch to see if you have power going in and out ?

First check fuse for brake light with test light if fuse is good test brake light switch under dash with test light if you dont understand how to do the above contact me at [email protected] title the message crown vic problem

you must replace the multi fuction switch! also known as the turn signal switch! its common on ford crown vic!

Sounds like a bad lighting control module. They were very problematic for '03.

Sounds like the multifunction switch. Try working the hazard switch up and down a few times to see if you get some lights to work. If so then replace the switch.

Check for missing brake light relay in central junction box behind battery. I had same problem with my 2004. Turned out the brake light relay had been taken out when car was take out of service.

i have a crown victoria with brake lights no tail lights could you help me?