- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
When you turn the key to start, what happens ? Does the engine turn over and not start ? Or does it not do anything ?
When you say that the starter seems ok, have you tested it ? Did you jump starter/solenoid and see if the engine turns over ? Are you getting power to the starter when turning the key to the start position ?
The one item I would suspect is the through-out-bearing not completely
disengaging the pressure plate from the fly wheel. If the vehicle is in neutral
and you slowly depress the clutch and release it do hear a singing or whining
sound? Since you cannot adjust the clutch any more the through-out-bearing is
the component which moves the pressure plate from the fly wheel to stop the
power from the engine to the transmission. It is difficult to shift when the
engine is on because the fly wheel is still engaged and powering your transmission.
The hydraulic clutch command has failed - either at the pedal pump or at the clutch cylinder. Verify first that the line to the clutch cylinder isn't severed; if it isn't the disconnect it, plug it so it doesn't leak and try to press the pedal -if you can the the pedal pump is faulty, if you can't it's the cylinder. Either replace the corresponding seals or replace the entire part.
either the throw out bearing has failed ot the clutch plate hub has failed
possibly from the clutch plate being installed incorrectly and the hub springs are hitting on the flywheel bolts
you have to reset your computer..it is kind of tricky..you have to pump the gas pedal three times on the third time hold it to the floor turn the ignition to on position then off then start the car it should reset it..
clutch goes to floor but does not stick
×