2004 elantra - front parking light replacement

no country told.
got DRL, day light running lamps> lamps on in the day , we need to know that first. or all answer 1/2 are wrong,
yes cars have 2 to for 4 fuse boxes. seems to me 1, next to battery only. here.
the glove box guide shows them all. lost it? it shows 1.
the fuses must be checked, ALL checked.
front lights means

• PARK lamps
• low beam heads
• high beam heads
• blinker, Turn sigs.

or all 4 or what?
scan t he PCm yet?

Is the high beam working or parking light ?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/paul_0aa451e2c4466dbf

engine compartment on the driver side the famous black box

check your fuses in side and in the motor compartment

First it is possible that both low beam filaments in bulb are burnt. Check fuses for low beam before replacing the bulbs.

use some decent bulbs and not them made in china cheap things

its kind of uncommon but I have seen both Low Beams burn out at the same time,but first check to see if your vehicle has a separate relay for the high beams and one for the low beams if so replace the low beam one if that is not replace both head lights,and it that is not it the only thing left is the head light switch itself.Hope this helps good luck

thats it my freind one on each side/Plaes rate my response thank you very much

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment
Fuse Panel Description
9 10A Right Front Low Beam
10 5A Left Front Turn, Left Front Repeater, Left
Front Sidemarker, Left Front Park Lamps
11 10A Left Front High Beam
12 — Not Used
13 5A Cluster
14 10A RCM, DATC
15 5A Not Used (Spare)
16 5A E/C Mirror, Heated Seat Controls, RSM
(Rain Sensor Module)
17 5A RCM, Alternator Warning Lamp
18 20A Radio, CIA
19 15A Tilt/Tele Motors
20 10A FEM, DATC, Cluster, Brake Shift Interlock,
REM
21 10A Power Folding Mirrors
22 10A DDM
23 10A Right Front High Beam
24 5A PATS
25 10A Left Front Low Beam
26 10A Wiper Relay, Windshield Washer
27 10A Radio, Cellphone
28 5A Security Horn
29 5A Trailer Tow Ignition Sense, VEMS, FEM
30 5A FEM
31 — Not Used
32 20A Cigar Lighter
33 10A Switch Backlighting
34 10A Not Used (Spare)
35 5A Stop Lamp Signal