My driver side heated mirror on my 2002 jeep liberty limited was sideswiped. How do I go about replacing it with a new one? I am hoping to find step-by-step instructions.

Usually there is a switch issue. The switch that allows you to select right, left or nuetral can go bad or get dirty and not allow power distribution. If you feel comfortable doing so, remove the trim and gain access to the switch. Using a test light or the schematics, find out which wire is the voltage supply and ensure it has power with the key in the on position but the motor need not be running. If no, suspect a fuse issue, if yes then suspect a switch issue. You can use a jumper wire to apply power to the mirror feeds (again a schematic would be greatly reccomended) and if the mirrors move, viola! I hope this helps

2002 Jeep Liberty Limited Edition 4WD 3.7 liter SOHC V-6 VIN "K"



Also, here can find the Jeep KJ Service Manual

Hope helps (remember rated this help) Good luck.

Several steps in here; review the KJ-2002-Liberty-Service-Manual-PDF-Secc-23-Body (page 128 and next).

I hope help you with this. Remember rated this help, good luck.

there is no fuse for this I would lean toward the switch. If you want to be positive it is the switch just the switch circuit and check your ground. Switch is pretty cheep for that.

First you need to remove the door skin , once this is removed you should see three screws that attach the mirror, remove them....if it is a heated mirror you will need to unplug and replug the new one in before attaching the new mirror...hope this helps

I am assuming the glass is broken. If so then take a small thins flat screw driver into the rear of the glass and it will pry away slowly, This will enable you to buy a "Ready-Cut" mirror from a neighborhood glass shop that can pop on in seconds.

Get the VIN number and call a dealer!

The door panel has plastic clips that hold it in place also. Put a thin blade screwdriver between the panel and door. Pry the panel away from the door. The panel will make a loud snapping noise, that is the clip coming out of the retaining hole. Sometimes the clips break.

When you open the hood look on the drivers side of the engine. There will be a pulley(Power Steering Pump) that your belt goes around, right under it on the back side is where your oil filter is located. It hangs down slightly angled towards the front of the vehicle. (This is of course the 3.7 liter V6)

you can order online the mirrors
and have them delievered
did you check the switch for the mirrors sometimes its just a simple fix as replaceing a faulty switch
the switch would go out faster then the conventional mirror would try a replacement switch