SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4
click on this link, and scroll down to 5.7L
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e
SOURCE: 1998 dodge ram 1500 4x4 stereo wiring
glad you posted what colors you do have , cause 2 resources didn't match ,actually 3 , i did find a match to your colors was a 97 year model premium radio, so we have a match .....
black/ light green = ground
dark green = left front spkr +
purple = right front spkr +
blue/white = right rear spkr -
brown/blue = left rear spkr -
brown/yellow = left rear spkr +
blue/orange = right rear spkr +
black/yellow = park lamps
brown/red = left front spkr -
orange = dimmer signal
pink = fused battery +
green/red = radio choke relay
red/white = fused ignition
blue/red = right front spkr -
cheers
djmac62 is also an excellent answer
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: check engine light on code
This trouble code is Evap Purge System Performance fault. 1) Check for a loose or missing fuel cap. 2) Check for a damaged or missing fuel cap seal. Recheck for other trouble codes. This fault wont cause the stumblering problem. It turns on the MIL lamp to say there leak in the EVAP system.
SOURCE: Dont know what kind of Transmission my dodge has
ON THE BOTTOM OF THE TRANY THERE IS A TAB ON THE SIDE OF THE TRANY ON THE BOTTOM LIP WHERE THE FILTER PAN IS BOLTED THE NUMBERS ARE STAMPED ON THE TRANY HOUSING ON THE BOTTOM NEXT TO THE PAN
4X4
On
these issue, there are few solved help links for troubleshooting the
issue easily.-------
Click
the link below: ---
http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html
-----------
http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html
-------------
http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html
--------------
http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html
------------
http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html
----------
http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html
----------
http://technoanswers.blogspot.in/2012/06/2002-jeep-wrangler-4wd-idiot-light-is.html
----------
Traction
control switch will not engage on 4WD High or Low
http://whoisbyme.blogspot.com/2012/10/traction-control-switch-will-not-engage.html
-----------
4WD light
flashing and 4WD will engage after few minutes
http://repairhelpcenter.blogspot.com/2012/10/4wd-light-flashing-and-4wd-will-engage.html
------------
http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html
----------
http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html
-------
-------------
http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html
----------
http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html
-------------
These
details will help.
Thanks.
160 views
Usually answered in minutes!
×