How to change a gmc yukon driver side exterior door handle. door handle has come lose

Search Results

How To Install Replace Inside Door Handle Chevy Equinox ...

? 9:02
https://www.youtube.com/watch?v=cY6asyM2R6g
Feb 2, 2012 - Uploaded by 1A Auto Parts
How To Install Replace Inside Door Handle Chevy Equinox 05-09 1AAuto.com .... found your tutorial on fixing my driver's side door handle for my 2006 Equinox. .... Door Handles Chevy Equinox 2010 2011 2012 GMC Terrain ...

How To Install Replace Inside Door Handle 2007-13 ...

? 9:05
https://www.youtube.com/watch?v=QonKLwhk2CE
Apr 2, 2015 - Uploaded by 1A Auto Parts
http://www.1aauto.com/interior-door-handle-driver-side-front/i/1adhi00417 1A Auto shows you how to repair, install, fix,change or replace a broken or snappe... ... 10, 11, 12, 13 Chevy Silverado, Tahoe, Suburban and GMC Sierra, Yukon Denali ...2007-2011 Tahoe Yukon Suburban Escalade Vent Section ...Missing: terrain

How To Install Remove Rear Outside Door Handle 2007-13 ...

? 10:02
https://www.youtube.com/watch?v=7ZUTqqEzpZg

It is not hard just time consuming first u have to remove in side panel. Then the barrier reach inside door and disconnect lock rod. After that done disconnect second rod then remove the two bolts holding handle to door. Handle is removed change key lock over if needed. Installed is reverse or removed

should be a plastic clip to pop it into

If there REALLY is a requiremert to wax the door handes (and I severly doubt it) let the dealer show you where it is noted in the owners manual. He will not be able to find it, I am sure. I am also sure you have no way of wining this battle, considering the 07 Yukon is long out of warantee. The best you can do is tell hi he's full of **** and a liar. BUT!! if he's the only dealer in town, don't do that. You may need him someday.

Either the handle broke, or the linkage rod came loose. Your only recourse is to remove the inner door trim panel to find the problem with the handle, and fix it.

you will have to remove the door panel, leave the window up. You will see how it is bolted in, remove the bolts(throx head i believe), place new handle on and rebolt. Good Luck Tim

It most likly broke inside. You will have to remove interior door panel to access all the bolts and rods to replace it.

I've got a 97 GMC Yukon XL, I have a problem with the inside door handle on the driver side. To open the door I have to pull the handle and give it a shoulder for it to open. I think my problem is my door latch, I think it's giving out? Help

I found this on another page, hope it helps:)

Remove the plastic cover behind the door handle assembly by removing one black 14mm nut from just above the door handle, and 1 screw (usually phillips) from the bottom of the plastic cover.
Remove linkages from lock cylinder and door handle assembly. Use a small flathead screwdriver to slide retaining clips forward, and linkages will come free.
Remove one black 14mm nut from the very top of the door handle assembly.
Remove one phillips screw drom the bottom of the door handle assembly.
Door handle assembly should now come free by pulling out slightly at the top, and pulling upwards.
Transfer lock cylinder and key minder light (if applicable) to new door handle assembly. Lock cylinder is retained by a single TORX bolt.
Reinstall in reverse.
TIP: If you lose or damage any of those black plastic coated nuts, order new ones. They are GM p/n 10067214 and should be around $0.58/each. There are two on each door.