Anonymous Posted on Dec 31, 2009

Noise coming from under 05 Chevy 2500 HD

Have an 05 chevy 2500HD 6.6L 4x4. When in reverse hear a rubbing like noise from under the truck. Put the truck in neutral and tried to see if there was any play in the driveshaft to see if the u-joint was bad but didn't notice anything. Changed the oil in the rear end (no murky oil). Have a friend who had the transfer case go bad in his 2500HD and made noises. This sounds like it is coming from the rear though. Brake pads have not started squeling and seem to still have wear left. Any suggestions?

1 Answer

Anonymous

Master 541 Answers
Posted on Dec 31, 2009

Anonymous

Master

Joined: Jul 29, 2009

Answers

541

Questions

Helped

215041

Points

1334

The parking brake rusts and makes a rubbing sound. it is inside of the rear disks. you have to remove the caliper then the caliper bracket. pull the disk off and inspect the parking brake. very common problemas most automatic trucks no one ever uses the parking brake

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

Have a 2001 chevy 2500 hd 4x4 truck that shifts into reverse but wont move.. I shift from park to neutral then drive to 3 to 2 to 1 and all seems good but it wont move in reverse,,, any info on this

Sounds like the reverse band or servo has gone out. Transmission shop needed for a confirmation.

Read full answer

Jan 10, 2015 • 2001 Chevrolet Silverado 2500HD

0helpful

1answer

I have 2001 chevy 2500 HD I start the truck I hear a grinding noise in front end when in park it makes noise for few seconds then stops will not go in forward or reverse sounds like 4 wheel drive trying to...

There would also be a 4WD switch on diff

Read full answer

Aug 20, 2017 • Chevrolet Silverado 2500HD Cars & Trucks

0helpful

2answers

Sometimes when i am in reverse my 2002 Chevy truck (2500 HD 4x4) will come to a stop and make a winding noise like you are spinning your wheels i will put it back in park and it will stop back in reverse...

Check transmission fluid

Read full answer

Jan 10, 2018 • Chevrolet Chevy Cars & Trucks

0helpful

1answer

Noise comming from transfer case on my 2007 chevy 2500 hd, was told at dealership that my steering box was bad, could that noise be from steering box, is box located in the same area as transfer case

No, the steering box is located in the left front and the transfer case is located in the center of the vehicle.If the vehicle has under 100,000 miles and it is the transfer case it should be under warranty.

Read full answer

Dec 15, 2010 • 2007 Chevrolet Silverado 2500HD

0helpful

1answer

My 05 Chevy 2500HD is making a grinding noise when decelerating, as in going down a hill. When applying pressure to the accelerator it stops. It sounds like its coming from the rear bottom.

It is the transfer case. It seems to be a big problem with the 2004 and 2005 models. They are not synchronized and bend the forks alot. The noise you hear is the chain rolling off the gear. Mine only did it when I was going over 45 downhill and not on the throttle for a few seconds. Hope this helps...

Read full answer

Apr 07, 2010 • 2003 GMC Sierra 2500HD

0helpful

1answer

Grinding noise front end.

I say it's the CV joints. You have to jack up under the lower A-Arm, to take the spring pressure off of it, to check them.

(Use jack stands, and wheel chocks behind the rear tires. Emergency brake On. Work on a hard level surface. Be SAFE! Trucks can be replaced, YOU cannot!)

Read full answer

Jul 26, 2009 • 2003 Chevrolet Silverado 2500HD

0helpful

1answer

2002 Chevy Silverado 4wd 2500HD noise

probaly dont have a problem your truck probaly has a gas engaged 4 wheel dr modual and what you hear is the gas modual engaging

Read full answer

Apr 03, 2009 • 2003 Chevrolet Silverado 2500HD

0helpful

1answer

1999 Chevy Blazer makes noise

Check your driveshaft universal joint (u joint). When the needle bearings go, this is the sound it makes. To check, chock all wheels front and rear, put in neutral, if 4x4, put 4x4 in neutral also, go under vehicle, grab driveshaft at u joint and try to turn back and forth, watching for play, wobble in u joint. U should be able to see it. Let me know how u do.

Read full answer

Mar 21, 2009 • 1999 Chevrolet Blazer

0helpful

1answer

Noises

You should check u joints for to much play.

Read full answer

Mar 12, 2009 • 1999 Chevrolet Silverado 2500

1helpful

2answers

2002 Chevy Silverado clunking noice when shift from 2wd to 4hi

It is somewhat Normal Depending on how Loud the Clunking is. This is a Common Complaint on the Chevy 4x4's. I have verified this through the Dealerships here in Oklahoma and they all say the Same thing But, I am with you, They should go into 4x4 without that Clunk for as much as we pay for them.

Read full answer

Jan 26, 2009 • 2002 Chevrolet Silverado 2500HD

Not finding what you are looking for?

View Most Popular

2003 Sierra 2500HD

Cars & Trucks

Have a 2001 chevy 2500 hd 4x4 truck that shifts into reverse but wont move.. I shift from park to neutral then drive to 3 to 2 to 1 and all seems good but it wont move in reverse,,, any info on this

2001 Chevrolet Silverado 2500HD

501 views

Ask a Question

Usually answered in minutes!

Check Out the Latest Top Trucks Report!

View all Fixya Reports

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for 2003 GMC Sierra 2500HD? Or just drag it here!

Related Topics:

Noise coming from under 05 Chevy 2500 HD