Knock sensor location 08 accord

The knock sensor on a 2003 Honda CRV is located on the engine block. Specifically, it is located under the intake manifold, which means it can be difficult to access. Here are the steps to locate and replace the knock sensor on a 2003 Honda CRV:

1. Disconnect the negative battery cable to prevent electrical shock.
2. Remove the intake manifold. This involves removing several bolts and electrical connections.
3. Locate the knock sensor, which is located near the rear of the engine block, under the intake manifold.
4. Disconnect the electrical connector from the sensor.
5. Remove the sensor from the engine block. This may require a special tool, depending on the specific design of the sensor.
6. Install the new knock sensor, making sure it is properly aligned and tightened to the correct torque specification.
7. Reconnect the electrical connector to the sensor.
8. Reinstall the intake manifold, making sure all bolts and electrical connections are properly secured.
9. Reconnect the negative battery cable.

Note that if you are not experienced with working on engines or are unsure of how to proceed, it may be best to seek the assistance of a qualified mechanic to replace the knock sensor on your 2003 Honda CRV.

https://my.prostreetonline.com/2015/02/13/dtc-p0325-how-to-change-a-honda-accord-knock-sensor/

Knock sensor is a single wire red/blue wire. Sensor is located by starter under intake manifold and according to schematic goes straight to ecm pin 9. Ground is engine ground.at base of sensor

4 cylinder or V6?

it is normally in middle of engine above oil filter

images for Knock sensor location on a 2001 Honda ...

Honda knock sensor p0325 - YouTube

? 6:41
https://www.youtube.com/watch?v=yacSiSJ5Vc0
Feb 17, 2014 - Uploaded by Cody the Car Guy
do you know where is the knock sensor on a 2005 Honda accord coupe .... 2001-2005 Honda Civic Cam ...

Civic knock sensor - YouTube

? 1:28
https://www.youtube.com/watch?v=D1jk5OxuOB0
Jan 18, 2015 - Uploaded by chriizt1an
96-00 civic ex. ... Civic knock sensor ... 2001-2005 Honda CivicCam Position Sensor TDC Sensor & Valve ...

Honda Civic Knock Sensors - AutoZone

This will be located on the side of the engine block and will simply unscrew. Screw the new one in and plug in the connector. You are done. Have the code cleared and this should eliviate any knocking that is heard upon acceleration.

I believe it is located under intake runner on passenger side like the 6 in an.MDX. It has to attach to the engine block to pickup vibrations from engine knock.

A green flashing "S" is similar to a check engine light. It is telling you that something in or on your transmission is not functioning correctly, such as the speed sensor or shift control solenoids. If it starts flashing and the speedometer stops working or the transmission shifts weird, take it to a mechanic.