My head lights will not turn off and iv already

The fact that both are out points to the headlight switch or connector. There's a separate fuse for tail lights but the head and park (front) lights are powered by a fuse link that controls a lot of other stuff you would notice. Reach under the dash and put your hand on the light switch, feel for the wires then feel the other side of the switch for a small button then pull the switch all the way on, depress the button and pull the switch knob and shaft the rest of the way out, now remove the special screw and the switch. I hope this helps. Take care. If you need more help from me use the testimonial button and it will show up in my email.

It can be faulty headlight switch or issue with its wiring. Or its faulty head light fuse.

==========

To troubleshoot the issue i suggest you few help links with appropriate solution. So you can follow the test and confirm what exact problem is there in your case of headlights not working:-----

Click the link below: -----

http://alltypesofpartsreplacing.blogspot.com/2012/12/headlights-not-working-high-beams-not.html

----------

These details will help.

Thanks.

The headlight gear seldom is bad. the problem is the arm on the motor and/or the connector rollers inside the motor. Replacement kits are on Ebay that fix both.
The lights not working sounds like a bad headlight switch. Riviera used the same switch so they are not to bad to find.

This problem sounds like a bad shorted headlight switch, remove the switch and replace it and this will solve the problem. you can unplug connector to headlight switch and light should go out. good day.

GM Lumina/Grand Prix/Cutlass Supreme/Regal 1988-1996 Headlight Switch - REMOVAL & INSTALLATION

Except With Head Up Display (HUD)
(see Figures 1, 2, 3 and 4)



Fig. 1: Headlight switch location and mounting-1988 Regal shown



Fig. 2: The headlight switch is secured with clips and screws-1990 Lumina shown



Fig. 3: Light switch location and attachment-1993 Cutlass Supreme



Fig. 4: Headlight switch assembly-1996 vehicle shown

1. Disconnect the negative battery cable.
2. Remove the instrument cluster trim plate by unfastening the retaining screws or simply unsnapping it.
3. If necessary, remove the air outlet trim plate. If may be secured with screws/bolts or clips.
4. If accessible at this time, detach the switch electrical connector.
5. Remove the switch, using one of the following procedures:
   1. Unfasten the retaining bolts/screws from the switch, then remove the switch from the instrument panel.
   2. Unsnap the headlight switch from the instrument panel.
   
   
6. If not already done, detach the electrical connector from the switch at this time.
   

To install:

1. Attach the switch electrical connector and fasten the switch to the instrument panel. If the switch is secured with screws, tighten to 18 inch lbs. (2 Nm).
2. Install the air outlet and cluster trim plates.
3. Connect the negative battery cable.

With Head Up Display (HUD)
(see Figure 5)



Fig. 5: The HUD incorporates the headlight, fog lamp and HUD switches

1. Disconnect the negative battery cable.
2. Remove the steering column opening filler panel.
3. Remove the instrument cluster, as outlined earlier in this section.
4. Depress the locking tabs, then pull the switch out.
5. Detach the HUD electrical connectors.

To install:

1. Attach the switch electrical connectors.
2. Snap the switch securely into the instrument panel.
3. Install the instrument cluster.
4. Install the steering column opening filler panel.
5. Connect the negative battery cable.

Hope this help (remember comment and rates this).

Did you check the fuse for the low beams? The high and low are on seperate circuits..
Good Luck...

Yep sounds like you need a new headlight bulb The flashing is the tungsten fillament inside of the bulb breifly contacting the broken halves together when hitting it..Replace the bulb and all should be good. Note some times the light may stay on ,, this is because the broken halves arc welt themselves and break again upon cooling after you turn lights off ...good luck

when the parking brake is released or the car is place on drive gear the lights should turn on, check the switches on both sides to see if they work if not replace them.

May need a instrument panel dimmer switch or headlight switch if they are made together.

Yes look at the switch it has a manuel setting.