2003 Toyota Tundra Limited Stepside truck. No brake light. But the 3rd brake light works. Already checked the 15 amp fuse by the steering column

The best solution you'll get from books at www.reliable-store.com

These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc

check to see if the release of the parking brake actually engages the warning light switch fully.

Well, check if you have brake lights to start with? If you dont have brake lights, it is possibly a brake light switch under the brake pedal or a stop fuse blown. ( with brake switch malfunctioning, this could set ur check engine light and also ur brake and abs light. Check this and get back to me. By the sounds of the other accessories not working, check your 10 amp guage fuse which i am not quite sure, could be under the hood or in the cabin. keep me updated.

Hey Stan the man,need your vehicles info.,year,make,model and engine size and Tommy on the spot here will send you a picture diagram of your rear brake assembly.There's a special spring tool you can get at auto parts store to remove and install springs,me got one.

i think the wired has a problem check the wired line that source of electricity, if has a problem change the wired line, and its working










thanks

Unscrew the screws that are securing the brake light cover to the body of the Tundra. Pull the brake light cover off the body of the Tundra. Place the screws in the brake light cover and set it on the bed of the truck. Pull the burned-out light bulb out of the light fixture and discard it. Insert the new brake light bulb into the light fixture. Pump the Tundra's brakes to make sure the new bulb is working correctly. Replace the brake light cover on the body of the Tundra and replace the screws.

Brake booster seal leaking.

The connector is at the back under the bunper by the frame......it should be a 3 way connector. If that's not it,check for a ground wire loose...good luck !

Hi my Name is Marcus . I have a 99 toyota corolla and i have problems with the brake lights . I have change the bulbs . I have check my fuses , i have also change the brake pad switch . I was told that i to change the brake switch with a part for Toyota Dealership . Plz help me

put a new bulb in it