Here is a video and manual for you.
Manual guide.
https://www.autozone.com/repairguides/Mazda-Tribute-2001-06/Power-Steering-Pump/Removal-Installation/_/P-0996b43f8038009a
SOURCE: Brake drum 2005 Escape
here is a diagram on how to remove your brake drum. please do not forget to rate and comment about your experience with fixya today.
Removal & Installation
CAUTION
Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.
To install:
CAUTION
Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.
NOTE
If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
Drum brake exploded view
WARNING
Whenever a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without correct metal-to-metal contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while the vehicle is in motion, causing loss of control. Failure to follow these instructions may result in personal injury.
SOURCE: how to replace power steering pump on 2002 ford
Take a picture of it before you take it apart so you know where everything goes.
1.Take belt off
2. Unbolt any bracket that the power steering pump is bolted too.( only if you have to unbolt a bracket)
3. Disconnect lines from steering pump
4. After replacing power steering pump fill with Auto. trans fluid.
5. After filling start car and turn wheel left and right a few times this will get the air out of the system and recheck fluid level.
SOURCE: tool to remove front brake caliper to replace rotor Escape 2005
Is it hex (like an allen screw) or is it a Torx or Torx plus? Torx are serrated.
SOURCE: Changing plugs and power steering pump on an escape
I have a 2002 Escape V6 w/ 100,000 miles and I just changed the plugs. If you have a V6, you will have to remove the Upper Intake manifold. It's not too bad. You'll new a gasket set from Autozone or NAPA for about $10
784 views
Usually answered in minutes!
×