How to reset the service light?

Here you go:

to reset the light with the doors closed key on press the gas down to the floor 3 times then the light should flash then its reset

Find how do you can reset service light or turn off board light maintenance indicator, Service light reset Audi A3, http://www.vipercar.com/index.php?route=product/product&path=555_562&product_id=3396

The full procedure how to reset oil service light Acura MDX. After an oil change, if you like to reset any maintenance oil light for Acura cars. Or any error which appears on the display.
http://resetservicelight.com/reset-oil-service-light-acura-mdx/

BMW Model E39 built from 1996~2000 will have a port like the one shown below. A Reset tool like a Peake R5 or R5-FCX is needed to reset the oil service or inspection service lights after required service.

1) If you have a reset tool then turn your car key to Position II but do not start the car.
2) Turn the cap counter clock wise on the Data Link Connector and insert the Reset Tool
3) Follow the instructions of your reset tool, different models may have different functions however they all create a short in PIN 7 to PIN 19 for a given amount of time.

OIL Service Reset requires pin 7 and 19 to be closed for 3+ seconds

INSPECTION Service Reset requires pin 7 and 19 to be closed for 10+ seconds

4) Once done, remove the reset tool and close the cap .
5) Your dash should light up with green lights at this point.
If the light did NOT reset after the above steps then you might be resetting Oil Service however an Inspection Service is needed.

Buy a service light reset tool. try www.biltema.se and look up part no, 15-1389.

did the sevice light come on before you serviced it? when you "serviced" it I assume you changed the oil and now need the service light reset.
I bought the 1998 S70. it got time to change the oil. Being how I am I changed the oil myself. I had to call dealership about resetting the service light.
they said $29.96.
I said 29.95?!!! how much if YOU would have changed my oil and reset the light?
they said $29.95.
so I learned you need to access the OBDII to reset the light.after service. hope this helps.

Press odometer reset/adjustment shaft in, hold in and turn key to run position. Keep holding in the reset shaft in for about 30 seconds. release shaft. turn key off. restart car. Service Light should go off in about 5 seconds.

To reset the MAINT REQ'D light, press and hold the select/reset button on the right side of the instrument panel. Turn the ignition on and hold until the light goes out.

This should get rid of the service light.

Joe.