Is there a way to remove inertia fuel cutoff on a ranger?

Fuel shut off switch may need to be reset. A friend of mine had it trip when he had a flat tire some years ago on ford car. The reset on his was behind the plastic piece to the right of where the video below. Video below shows fuel shut off/inertia switch on upper floorboard passenger side.
Inertia Switch Explained Removed and Replaced 98-12 Ford Ranger - YouTube
2002 Ford Ranger Fuel Cutoff Switch - YouTube
You can try swapping out your fuel pump relay to make sure the relay is not bad. Below link may help
1999 Ford Ranger Fuel Pump Relay, Fuel Pump Fuse & Starter Fuse Location - YouTube

Doesn't have one , not honda .

pull the relay-- their is no fuel cutoff--fuel reset -or inertia switch on vehicle

Before going there, check your INERTIA SWITCH (INTERTIAL CUTOFF SWITCH). A small accident or a sharp bump can cause the cutoff switch to trip. The switch is located adjacent to the passenger side rear shock tower, and there is a pushbutton to reset (on most Topkick tucks). Carbureted Topkick trucks do not have cutoff switches, and some custom trucks have the inertia switch relocated.

MB doesn't use a reset switch (AKA Inertia switch) for the fuel pump

Try crankshaft positioner. It needs to accurately report rpm to the ecm to kick up fuel pressure. Check Inertia switch for fuel cutoff and reset.

Have you checked the fuel cutoff switch?

Print

GENERAL INFORMATION

This switch shuts off the fuel pump in the event of a collision. Once the switch has been tripped, it must be reset manually in order to start the engine.
The inertia switch is located on the driver's side of the vehicle behind the kick panel near the driver's feet.

RESETTING THE SWITCH

See Figure 1

Fig. Fig. 1: The inertia switch reset button is located on the top of the switch

1. Turn the ignition switch OFF .
2. Ensure that there is no fuel leaking in the engine compartment, along any of the lines or at the tank. There should be no odor of fuel as well.
3. If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.
4. Cycle the ignition switch from the ON to OFF positions several times, allowing five seconds at each position, to build fuel pressure within the system.
5. Again, check the fuel system for leaks. There should be no odor of fuel as well.
6. If there is no leakage and/or odor of fuel, it is safe to operate the vehicle. However, it is recommended that the entire system be checked by a professional, especially if the vehicle was in an accident severe enough to trip the inertia switch.

REMOVAL & INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the driver's side kick panel.
3. Unplug the connector on the inertia switch.
4. Remove the retaining bolts and remove the switch.

To install:

1. Installation is the reverse of removal.

Hello tbrank56,

If you are looking for the inertia fuel shutoff switch it's located below the right hand side of the instrument below the glove box.

Regards,
netvan

Who cares if it is a safety system? my 05 won't even make it out of the driveway without the thing going off and killing my truck. All because I hit a pothole. If you know how, please tell us. I took it into the shop and the mechanic got 2 new switches from Ford and neither one fit. So either I am going to have spend another $1000 dollars because you have a moral stick up your you know what, or you could help us out.

not sure what you are looking for?? there is no fuel cut oof switch in these vans. Not factory anyway. if you could elaborate on what you are looking for and or why.