2005 chy sebring drivers side wiper noisey and won't wipe the windshield. I have replace the wipes several times with no luck.it also has a chirp from the linkage, when it startes.

Hi Justin , Do you know what a SJB - smart junction box is and where it is located on you escape ?
Windshield Wiper Operation
The smart junction box (SJB) supplies power to the multifunction switch from the SJB fuse 25 (20A) when the ignition switch is in the ON or ACC position. The multifunction switch supplies power to the windshield wiper motor for the HIGH or LOW/INTERMITTENT input, depending on the multifunction switch position selected. The SJB also supplies power directly to the windshield wiper motor from fuse 25 (20A) when the ignition switch is in the ON or ACC position for RUN/PARK operation. When the multifunction switch is in the LOW, HIGH, or INTERMITTENT position, power is supplied to the windshield wiper motor, which moves the wipers off the park position. Once the wipers are off the park position, an internal switch in the windshield wiper motor switches to the run/park position which directs power to the wiper switch then back to the wiper motor. This maintains power to the windshield wiper motor to complete the wipe cycle. When the cycle is complete, the internal switch in the windshield wiper motor switches back to the park position. If the multifunction switch is in the LOW or HIGH position, power is supplied from the multifunction switch and another wipe cycle starts. If the multifunction switch is in the INTERMITTENT position, the windshield wipers remain parked until the internal relay in the multifunction switch supplies power to the windshield wiper motor. The internal relay supplies power after a time delay that is determined by the 1 of 9 intermittent switch settings.

Check wiper transmission arms ..usually located under the cowl below the windshield.. fittings could be worn or loose..

Try replacing the arm also. There might not be enough tension in the arm pushing on the blade.

You will need to find where in the linkage the problem is. I would start taking it apart to see what is and what isn't working correctly. Autozone website has free repair manuals available online.

Worn & or loose linkage

Hi You should replace it with a new switch. Good luck.

Check the fuse and the wiper relay?

bad wiper switch or the electronic board in the wiper motor has a short in it.

The splined fitting is pressed into the linkage. The fit became loose so that side will not operate correctly no longer. You will need to remove replace the complete linkage

It is likely that where the wiper arm is attached to the linkage  it is either loose or stripped.