Radio removal in 2006 toyota corolla s - 2006 Toyota Corolla

SOURCE: How do I replace the fuel filter on my 2006 Toyota Corolla?

ITS A LIFETIME FILTER AND WITH REGULAR USE, SHOULD NEVER NEED TO BE REPLACED

SOURCE: 2006 toyota corolla - rotors

The large bolt that you see is the nut that holds the axle shaft to the hub. You do not need to remove it to remove the rotors. You just need to remove the caliper & the caliper bracket. Normally, the rotors come off of the hubs easily, but sometimes, they rust onto the hub. My techs beat and beat and beat until they come off. With large hammers. Note that after they are beaten off, the rotors are no longer viable for re-use.

SOURCE: need belt schematic for 2006 toyota corolla

I can get you a diagram on monday but it goes from the alternator to the power steering pump then around the tensioner pulley then around the crank pulley then to the a/c compressor then pull on the tensioner to give you some slack and slip it on the waterpump.I hope that helps.Let me know if you still need the diagram

SOURCE: 2005 Toyota Corolla Radio fuse

Pg. 250 of your 2005 Owner's Manual shows the location of the Fuse Boxes. There is one under your hood on the driver's side and the other is under the dash just to the left of steering wheel. Pg 272, will show you how to replace the fuses. Pg. 286-287 gives a diagram and description of each fuse and what part of the electrical system it enables.
This portion of the electrical system correspondeds to the fuse in position 32 on pg. 287 of the manual.
Your going to have to get on your back with a flashlight and open up the fuse box under the dash by the steering wheel. The lid of the fuse box shows the positions of the fuse and their amperage rating. Like I said, replace the fuse in postion 32 (15 Amp). There is a spare 15 Amp fuse in the fuse box under the hood (easy to get to, see the diagrams in the owner's manual). There is also a fuse puller tool next to the spare fuses.

SOURCE: need instructions on how to remove my 2005 toyota corolla radio

Tools required: Phillips screwdriver, small flatblade screwdriver, rachet with 6 inch extension & 10mm socket.
1. Remove negative battery terminal (for stray voltage & airbags.)
2. Remove gear shift trim
3. Remove cable attached to lighter socket.
4. Remove center climate control knob and screw beneath it.
5. Gently pry both bottom corners of climate control face (up then towards the rear) until clear of lock.
6. Pull entire climate control console rearward until clips release. Leave all wiring attached.
7. Remove 4 bolts under radio (10mm.)
8. Gently pry between dash and AC ducting panel (both sides) and pull out.
9. 4 clip hold radio to ducting panel, gently pry while pulling radio out the back.
The rest should be easy...
9. 4 clips hols radio to