2005 Mazda Tribute gas pedal freezes in cool weather

Your water pump is starting to go out... replace it before its leaves you on the side of the road with serious engine damage!!

Mazda Tribute Questions - CarGurus

www.cargurus.com > Questions > Mazda

CarGurus2001 Mazda Tribute 3.0 Wont Start. out shopping one ... 0. Report. rebel54 asked a2005 Mazda Tribute i Maintenance & Repair question about a month ago ...

Tribute won't start - Mazda Forum - Mazda Enthusiast Forums

www.mazdaforum.com > ... > Mazda Vehicles > Mazda Tribute

May 22, 2007 - I have a 2002 Mazda Tribute V6. On Sunday it wouldn't start. ... 2005Tribute won't start! rizakag, Mazda Tribute, 4, 03-27-2006 09:29 AM ...
Why does my fuse in my 2005 mazda tribute keeps blowing ...www.cargurus.com > Questions > Mazda > TributeCarGurusSep 4, 2014 - Why does my fuse in my 2005 mazda tribute keeps blowing when I try to switch gears?Electrical problem - 2004 Mazda Tribute - RepairPalrepairpal.com > Questions > Mazda > Tribute > 2004 Mazda TributeApr 5, 2011 - Electrical problem on 2004 Mazda Tribute ... meter on the battery cable note the battery draw then remove fuses one at a ... 2005 Mazda Tribute.2005 Mazda Tribute, Fuse #3 Blows, No Tail Lightswww.sparkys-answers.com/.../2005-mazda-tribute-fuse-3-blows-no-tail.h...

I'd the check engine light on? Have you checked to see what codes are present if it is on?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Fix your car right away by clicking the link I attached 2001 Mazda Tribute Workshop Repair Service Manual PDF Download

its an ignition coil sir.
it cuts the spark off when get hot so check / replace coil

Welcome to FIxYa.com

Clean throttle body with throttle body cleaner--butterfly is sticking

\

Regards, Lee Davidian

Thank you for using FixYa,com.

Try spraying latch assembly liberally with WD-40 or similar product and silicone to prevent freezing

If that doesnt help replace the latch.

I don't have the solution but I can back you up, my 2006 Tribute does the same thing when it's around freezing the first time or two I push on the gas.

The stop light switch is sticking. If it's a mechanical one that is operated by the movement of the brake pedal the replace the switch. If a hydraulic one is fitted, remove one wire and see if the stop lights go off. If so then replace the hydraulic switch.

locate the cable from the motor. disconnect,hold up high spray wd-40 into cable,lots cause you want it to run all the way through