Hi i have a mercedes c180 saloon 2002. i get no air blowing out my driver side footwell vent and for the driver side windscreen vent the air only blows at a really low force for about 30 seconds when i start the car, after that the vent closes, but the passenger side is fine. i also get a clicking about 30 seconds after i start the engine, and it lasts for about 2 minutes, the noise comes from the dash near the centre windscreen vent, does anyone know what the problem could be and the costs of fixing it thank you
SOURCE: Driver's side vent does not blow cold air when AC is on.
hello,seems you need to renew your dryer tank,this is a know problem,just dryer tank,ty
SOURCE: 96 Mercedes c280 ac only blows out defrost and side vents
you have a vacuum leak. also check your vacuum canister it looks like a round black ball some time is under the fender.
SOURCE: water in the rear passenger footwell
Not unless it was blowing like stink. Was a rear window left open? Water could get in around the rear window and find it's way there. Have someone spray the car with a hose while you're in it or ride back there through a car wash. Have a friend help and you buy the treat.
SOURCE: Driver side not blowing cool air
hello,good day,please renew your dryer tank,this a well know problem,ty
SOURCE: How do i fit a replacement nearside wing mirror
You'll need a screw driver (philips is most common), a plastic prying lever, socket (should be 10mm, but can't remember)
If you're lucky, on the inside of the door, will be a triangular panel
right behind the mirror that you can pop off. If you're not as lucky
and it's one piece or the panel is blocked by the door panel, you'll
need to remove the door panel to change it.
On the inside trim,
you can remove screws (these screws may be covered by filler pieces or
may be visible, or they may require you pry a plastic piece off that
covers the screws) that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can remove the bolts
holding the mirror onto the door
------------
Heater blows cold?
http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html
-----------
Heat blows cold on drivers side and hot on passenger side?
http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html
----------
No heat, blower blows only cold?
http://technoanswers.blogspot.in/2012/02/no-heatblower-blows-only-cold.html
------------
These will help.
Thanks.
429 views
Usually answered in minutes!
×