1993 Jeep Wrangler Logo

Related Topics:

Posted on Dec 12, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

I have a 1993 4.0 jeep wrangler. I put in a new fuel pump, The jeep still has a hard time starting and when it dose it stops running after 15 sec, I checked the fuel filter and it was ok?

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 1,498 Answers
  • Posted on Dec 12, 2009
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 11, 2008
Answers
1498
Questions
6
Helped
726358
Points
4881

Hi There,

Had the same thing going on with my '91 Wrangler. After checking what seemed like every other component, I finally pulled the injector rack.

I found all six to be gummed up to some degree. Cleaned them up. put on new o-rings and reassembled.

Fired right up and stayed that way

Mike

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

95 jeep wrangler extended crank time.

This system requires rpm signal before it will power up fuel pump .
THE PCM POWERS UP THE FUEL PUMP FOR TWO OR THREE SECONDS AT KEY ON !
0helpful
1answer

I have a 1994 wrangler.must crank starter multipul times for fuel to reach fuel rail on 2.4 or 2.5 4 cyl.Once finally starts will run great all day and start.Next day starts hard again.I replaced fuel

replace the fuel pump,the check valve that holds pressure on the fuel is in the fuel pump.The fuel in the lines is draining back into the tank
0helpful
1answer

I just bought a 1993 jeep wrangler, its a 2.5L and i cant seem to get it running here is what i did so far, WHEN you roll it over it hits and hits and hits it just wont start up, it has bran new pulgs,...

well you have done everything i would have done ,except take a old plug and pull a lead off any cylinder then put the old plug onto the lead and crank engine to make sure you have a spark
1helpful
1answer

My 95 yj hard too start after i change my fuel

when it does not start you need to verify no fuel pressure, Most likely your problem is the wiring harness is bad which will destroy a new pump if the pump is not geting the voltage required.
0helpful
1answer

I have a 93 Jeep Wrangler 4.0 that cranks and doesn't wanna start. Fuel Pump is working and has good fuel pressure. Problem is coil loses power after the first start. I put in new distributor, new coil,...

Ok...you mentioned that there is no spark coming from the coil when it's in no start...Is there power from the alternator going to the coil?
One other item...If the timing chain is worn and stretched, it is possible that the cam sensor and crank sensor are out of phase with each other, just enough where a temperature difference will change starting ability.
One question...while in no start, have you tried changing the throttle position while cranking to see if it lights at part or 3/4 throttle?
0helpful
1answer

1998 jeep wrangler starting issues

Hi Dava224 i had the same problem with my 1989 CJ. when it was cold out i would pump the gas pedal 3-4 times before turning the ignition. it puts a small amount of fuel in the motor without stalling it out. it wont start as hard. another good idea is to keep some fuel stabalizer in the tank everytime you fill up. hope this helps
0helpful
2answers

2007 Jeep Wrangler x will not start. put new fuel pump but still will not start. Feul pump does not kick on when key turns>???

check to see if their is any fuses blown or change out the fuel pump relay and also check to see if the ground to the fuel pump is getting a good connection these things should solve your problem.Good luck
0helpful
1answer

Hard starting wrangler

your fuel pump is bleeding off have it checked!
Not finding what you are looking for?

258 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...