I need to change the gear selector knob on a 1994 mark 8 how does it come off?
Shift Control Linkage
The transmission range selector control linkage consists of the following components:
-------------------------------------
Section 07-05: Transmission, Automatic—External Controls
1996 Mark VIII Workshop Manual
REMOVAL AND INSTALLATION
Gearshift Lever
Removal
Console Panel, Floor
Removal and Installation
Console Panel, Floor
Item
Part Number
Description
1
046A44
Radio Finish Panel Assy
2
047A74
Console Glove Compartment Mat
3
045A36
Console Panel
4
N804234-S36
Screw (2 Req'd)
5
N800322-S36
Screw (2 Req'd)
6
N805180-S58
Screw (2 Req'd)
7
N806577
Nut (2 Req'd)
A
—
Tighten to 2.5-3.1 Nm (22-27 Lb-In)
Installation
Section 07-05: Transmission, Automatic—External Controls
1996 Mark VIII Workshop Manual
REMOVAL AND INSTALLATION
Bezel, Transmission Control Selector Dial
Removal
Remove transmission control switch using a small screwdriver and gently prying between switch housing and knob assembly.
Remove retaining clip from gearshift lever knob (7213).
Hold gearshift lever knob securely and press release button.
Pull up on gearshift lever knob.
Remove console finish panel (04567). Refer to Section 01-12 .
Remove indicator selector dial bezel retaining screws. Raise transmission control selector dial bezel (7D443) and disconnect transmission range indicator lamp. Remove transmission control selector dial bezel.
Item
Part Number
Description
1
7213
Gearshift Lever Knob
2
7G550
Transmission Control Switch
3
—
Transmission Shift Control Selector Lever (Part of 7210)
4
7210
Gearshift Lever
5
7D443
Transmission Control Selector Dial Bezel
6
—
Transmission Control Switch Wire Harness (Part of 7210)
7
—
Selector Knob Retainer (Part of 7213)
Installation
Replace bezel over shift lever while lining up indicator slot with indicator driver.
Fasten retaining screws and connect the transmission range indicator lamp connector.
Position transmission range selector lever in PARK.
Position transmission control switch wiring connector against shift lever notch and hold while sliding knob and shroud assembly over transmission control switch wiring connector.
Install shroud and knob assembly into slide opening and press shift knob onto shift lever firmly.
Verify gearshift lever knob is installed completely onto lever and install retaining clip.
Install transmission control switch into gearshift lever knob .
Replace console finish panel. Refer to Section 01-12 .
Check transmission range selector lever for proper operation.
Check transmission control switch for proper operation. Instrument panel light should indicate switch function.
×
1,431 views
Usually answered in minutes!
×