How do I R&R front motor mounts on 2000 cadillac sts

sounds like the solenoid is engaged throwing the bendix into the flex plate and allowing current into the starter motor, things to check 1 make sure the bendix is not sticking holding on the solenoid , the solenoid lets more power flow to the starter from the battery. 2 faulty solenoid, 3) faulty ignition switch... hope that helps

1979 Cadillac Coupe 425 engine running; flywheel knocking

? 1:16
https://www.youtube.com/watch?v=UTDBmkKyBCY
Sep 30, 2011 - Uploaded by Edgar H
1979 Cadillac Coupe 425 engine running; flywheel knocking ...Change Transmission Fluid pan removal Cadillac Seville part1 - Duration: .

Exclamation Re: Found a 94 STS for $800, needs flywheel ...

www.cadillacforums.com/.../cadillac-seville-cadillac.../65815-found-94-s...

Feb 16, 2006 - 15 posts - ‎9 authors
Cadillac Seville / Cadillac Eldorado Forum Discussion, Found a 94 STS for $800, needs .... If it is somehow just the flywheel, your repair cost would be the labor involved in dropping ... Automobile(s): 1999 STS - diamond white. Re: flywheel 99 sts
14 posts
Apr 7, 2013
Re: need to replace flywheel
3 posts
Dec 3, 2011
Re: Location of transaxle to engine bolts on 1998 ...
15 posts
Nov 13, 2011
Re: How to lock flywheel without $150 tool?
7 posts
May 21, 2009
More results from www.cadillacforums.com

followthis link to a caddy forum for expert advice and tips
1999 STS security problem

the diagram should be affixed to the top of the stereo

Are you thinking the relay that controls the wiper motor ? The owners manual should have a section for fuses and relays. The wiper motor is controlled by a relay because of its higher current draw. It should be located in one of the fuse panel/blocks.

Buy the factory service manuals from
Helm.Com & follow the trouble charts

Center rear of the engine compartment, near the power brake booster

Depends on what the problem is.
Do you have power in and out of the brake light switch ?
And in and out of the turn signal switch ?

1998 Cadillac Seville STS 4.6L SFI DOHC HO 8cyl


Fig. 4.6L engine starter mounting is under the intake manifold (click for zoom)



Fig. This is where (and how) the starter motor is mounted in the engine valley on the 4.6L engine. The arrows show the 2 mounting bolts

Hope helps (remember comment and rated this).

then the ride control will not work at all