I know alot of crysler/dodges had a crank sensor i had 1 go out on mine check see if you got 1 chances are thats it when mine went out it would turn over but no spark
I have the same problem i replace 3 fuses and next day my van wouldnt start so i replace the starter relay and then it starter next day it wouldnt start again took the 3 fuses out and replace the relay and still wont start it acts like theres no power from the key to the starter i don't know whats wrong either
SOURCE: Dodge ram van stalls when RPM are low
could be fuel filter clogged //fuel pump is going bad which you will need to have a pressure test done ...also is there a gas odor ? could be rusted lines could be air filter ....messing with the timing you should not move to much ...if you have brake /carb choke cleaner try spraying around the intake manifold to see if any change in performance such as lowering the rpm's which would mean a gasket leak are all the Vacuum lines good and not dry-rotted try bending them ans well as spraying with a squirt bottle of water on the plug wires to see if an Arc is present a bad plug wire ..these are a few areas in which i would consider 1st ..hope this helps you
SOURCE: 98 dode ram wont crank no spark
May have no spark due to a bad crank sensor, which is responsible for spark when it gets a pulse through the cars' computer.
SOURCE: 1994 Dodge Ram Van 2500
3 things must happen to engine start
spark you have
fuel you have
compression dont know
if compression to low extremly hard to start
check your air filter is it foulled up--------replaced
when cranking engine is there pressure at the exhaust -- if not disconect to test
if all this is ok
check timming maybe chaine hase jump a few teeth that will make a no start
ussually backfires when it jumps
1,536 views
Usually answered in minutes!
I have replaced the pick up coil,crank sensor, ignition coil. The coil is not getting power. The linkable fuses have been repaired. I can't figure out what is wrong.
what parts have you replaced and is your coil getting power
×