Were is the abs sensor mounted on the rear of an

should be clips along the brake hose it clips in to

98 grand cherokee limited 5.2L same problem found leak not from heater box but from drain mount on firewall under the glove box not behind it. drain line should be located behind right front tire in the frame. Turn your wheels hard left look inside fender well right side towards back side. hole in frame where drain line should come out.

The horn for the Jeep Grand Cherokee is mounted under the right turn signal behind the front bumper. The easiest way to access it is from underneath the front of your SUV.

Removal

1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper, caliper anchor, rotor and ABS wheel speed sensor.
4. Remove the cotter pin, nut retainer and axle hub nut.
5. Remove the hub/bearing mounting bolts from the back of the steering knuckle. Remove hub/bearing from the steering knuckle and off the axle shaft.

Installation

1. Install the hub/bearing to the knuckle.
2. Install the hub/bearing-to-knuckle bolts and tighten to specification.
3. Install the hub washer and nut. Tighten the hub nut to specification. Install the nut retainer and a new cotter pin.
4. Install the brake rotor, caliper anchor, caliper and ABS wheel speed sensor.
5. Install the wheel and tire assembly.
6. Remove the support and lower the vehicle.

ambient temperature sensor located behind front grille mounted to bracket on the radiator.

HI!!

The only things you have to take off is the tire and the brake drum, which comes off just by pulling it off, it may need a some effort, if too tight, hit it a couple of times with a hammer, (not too hard) to loosen it up.

The sensor is bolted to the backing plate in front of a toothed wheel which is part of the axle shaft, right behind the wheel studs.

Note the position of old sensor and install new one in same place.

If helpful, click below, Good Luck

you need to have the codes reads to know which wheel's speed sensor is faulty

probably a bad sensor in one wheel. If your car go to one side when you apply brakes, the sensor of the opposite front wheel is defective or loosing. if not, rear wheel ones

Ask your mechanic what specific codes he extracted from your vehicle's computer and repost.

this vehicle has three sensors two front and one on the rear end this sounds like most of your problems but have all your brakes checked .thank for your question