The horn and power locks don't work on my focus

Your Focus may be equipped with the autolock feature. Try this:

To deactivate/reactivate the autolock feature using the power door unlock control

You must complete steps 1-7 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds.

1. Turn the ignition key to ON.
2. Press the power door unlock control three times.
3. Turn the ignition key from ON to OFF.
4. Press the power door unlock control three times.
5. Turn the ignition back to ON. The horn will chirp.
6. Press the unlock control, then press the lock control.
The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated.
7. Turn the ignition to OFF. The horn will chirp once to confirm the procedure is complete.

??? not sure what your asking or saying. if your saying horn was hit and now doesn't work, check the connection on horn & if you have a meter check if it has power while someon is pressing horn,check fuse/breaker or you need new horn.

Sounds like the horn has packed up ?? could be wrong but try a test wire to it see if it still works

Check your fuzes

Owner's manual should have a diagram of the fuse panel. Need to find which fuses control these items and check the fuses.

hi , if like a similar problem i had years ago , the problem is either a bad connection on the steering wheel or an earth fault on the horn its self ? the car i had the fault on was a mk1 golf and under the steering wheel was a copper strip round the neck of the wheel where its connected to steering rod.....the connection (similar to a motor armature brush) was not making a good connection, i cleaned them with wire wool and hey presto. hope this helps??

there are two seperate horns

I really think it is the fuse. It is a pain in the **** to access but mine was blown.

Driver door module is where to look also a broken or corroded wire and if you use your key to punch in the door code then the key pad has a hole in it or it just went bad it's not the remote control also check the master door lock switch for corrosion at the pins and the plugs same with the driver door module