Can I add factory cd system now?

Do you have base or up;level system ?

Table 1: Radio Features
Table 2: Cassette Features
Table 3: Compact Disc Features
Table 4: XM Advisory Messages
The radio receives power from the RADIO fuse in the junction block-right I/P. Ground is provided via G201 and G202. The radio is enabled/disabled by class 2 messages from the body control module (BCM). The radio routes audio signals from the digital radio receiver or the vehicle communication interface module (VCIM) to the speakers and/or amplifier when directed by class 2 messages.
The Entertainment System on this vehicle is configured with an AM/FM stereo radio with the radio data system (RDS) and either a cassette player or a CD player or both. CD and cassette. The uplevel system provides the customer with extended range speakers and an audio amplifier. Satellite digital radio (U2K) is available with uplevel systems.
The following list shows the radios available for this vehicle:
• Radio (ULO) - AM/FM Stereo, Cassette with RDS
• Radio (UNO) - AM/FM Stereo, CD and RDS
• Radio (UPO) - AM/FM Stereo, Cassette with CD and RDS .The complexity of the radio systems on these vehicle is mind blowing .

Your best bet take it to a GM dealer , has features you are unawear of .
DTC B1025, B1035, B1045, or B1055
When the radio is powered up, the radio supplies low level audio signals to the speakers. If the vehicle is equipped with an audio amplifier, the amplifier will boost the signal sent to the speakers.
DTC B1025 Audio Output Circuit
Install a scan tool.
Turn ON the ignition, with the engine OFF.
With the scan tool, monitor the DTC Information for DTC B1025.
Does the scan tool indicate that DTC B1025 is current?

No second harness. You have a bad cd player. Optional plugs may be for on star, steering wheel controls, cd changer etc.

Maxima Bose Radio ' eBay

www.ebay.com/bhp/maxima-bose-radio

eBay1995 1996 1999 Nissan Maxima Pathfinder Infiniti J30 Radio BOSE CD tape Player ...Will fit and work in these with BOSE audio package only:1995 - 1999 NISSAN .... 2006Nissan Maxima OEM Bose Cassette & 6 Disc CD Player Radio CR13B ...DESCRIPTION Unit is missing some bottons, 3 of them, this item has NOT ...

Nissan Maxima Bose Stereo ' eBay

www.ebay.com/bhp/nissan-maxima-bose-stereo

eBayWill fit and work in these with BOSE audio package only:1995 - 1999 ... 1996 - 2000 NISSAN Pathfinder. 2004 2005 2006 NISSAN MAXIMA FACTORY BOSE STEREO 6 DISC ... Factory NISSAN INFINITI BOSE Radio, Tape, and CD Player. ... 6 Disc AM FM Stereo Cassette Radio Bose OEM LKQ (Fits: Nissan Maxima).

Nissan Maxima Car Stereo Removal and Repair - YouTube

? 8:52
https://www.youtube.com/watch?v=RT-SZEfeA4Q
Sep 16, 2012 - Uploaded by Factory Car Stereo Repair
Factory Car Stereo Repair .... I have nissan maximal 05..the CD part turns on but the cd won't eject...should ... I have a 2005maxima non-bose radio system. ... my speakers is super in my 05 maxima but my cd player keeps on ...

Nissan - Factory Car Stereo Repair

Go to a Salvage Yard or contact Car-parts.com which is a collection of online parts salvagers. There were optional radios which had this feature and also a 6 CD stack for the trunk.

The biggest thing would be to make sure the wiring is compatible if going to a trunk mount. But a dash mount single radio/CD is probably the cheapest way and I would think the speaker wires should be compatible.

The manufactuers used a 4 pin lock system in the front dash facing of the radio. You can get the simple release pin barbs at Walmart or most autoparts places. Just insert the barb pin stems into the 4 square holes and press and the radio should come out.

check your fuses first. You may have blown one.


Visual Inspection Chart Mechanical Electrical

• Integrated control panel (ICP) physically damaged, misaligned, any control(s) inoperative
• Digital audio compact disc player physically damaged, misaligned, any control(s) inoperative
• Antenna or antenna cable physically damaged, misaligned connection(s)
• Radio speakers, mounting/speaker cones physically damaged, misaligned
• Radio ignition interference capacitors, radio frequency interference suppression bond misaligned (also check for cleanliness and metal-to-metal contact)

• Battery junction box (BJB) fuses F127 (5A), F117 (20A), F127 (5A).
• Central junction box (CJB) fuse F227 (10A) F211 (15A), F216 (15A), F226 (10A) (wagon only)

1. If the fault is not visually evident, proceed to diagnose the integrated control panel (ICP) by entering the ICP Self-Diagnostic Mode.

ICP Self-Diagnostic Mode
NOTE: To enter the ICP Self-Diagnostic Mode, the ICP must be ON and in radio tuner mode (AM/FM).

1. Enter the diagnostic mode by pressing and holding preset buttons 3 and 6 simultaneously. This will suspend all radio functions, and display SP.

1. Preset Button 1 = Audio internal/external SELF TEST. The display will flash SELF while gathering the diagnostic trouble codes (DTCs), then stop flashing when complete. Press the TUNE UP button to display the DTCs if any exist. Record codes and refer to the following table:

ICP SELF-TEST CODES Code Description 0 No diagnostic trouble codes logged 1 No response from rear chassis unit (RCU) 2 No response from cassette player 3 - 4 No response from compact disc player 5 - 6 - 7 No response from remote climate control 8 - 9 Read Only Memory Verification failed

1. Preset Button 2 = Displays the feature strap for code identification, refer to the following table.

Code Description 01 Base-Electronic Search Radio (ESR) with Manual Climate Control (MCC) 07 Electronic Search Radio with Cassette (ESC) with MCC 17 ESC with Electronic Automatic Temperature Control (EATC) 97 Not programmed default of ESC with EATC

1. Preset Button 3 = ICP and RCU identification. This test identifies the software level of the ICP and RCU. The ICP is tested first, followed by the RCU. The display will have two sequences of three codes each. The first sequence is for the ICP, the second sequence is for the RCU. For code identification, refer to the following table:

Item Part Number Description 1 - Product variant code 2 - Tape model 3 - CDR


SOFTWARE IDENTIFICATION CODES Product Type Code Description Product Variant Code Description 21 ICP 07
08
09
10
11
12 EATC with AM/FM, cassette player and CD changer
EATC with AM/FM and cassette player
Manual A/C with AM/FM and cassette player
Manual A/C with AM/FM
EATC with AM/FM and cassette player
EATC with AM/FM cassette player and CD changer 31 RCU 01
02
03 Analog
Digital
Midline 71 Remote climate control 01 LH drive 52 Compact disc/disc jockey 01
02
03
04 Sony® 10 disc
Sony® 6 disc
Clarion® 6 disc
FMS 6 disc

I have a 2003 Mazda MPV that has the stereo that you could add a cassette deck or MD to...I do not have either, but there is a button for it. I found a guy on the internet that made a chip that plugs into the back of the radio and has a 3.5mm jack on it that will play when you push the cassette/md button on the radio. It is great....sounds just like one that came from the factory.

Disconnect the battery ground lead.

1. Remove the radio/cassette player and CD player (if fitted
2. Remove the bezel with the heater/air conditioning control panel.
3. Remove bezel with heater/air conditioning control panel .

Remove the heater/air conditioning control panel from the bezel




you will need this tool shown below to remove the factory radio

It will work as long as it's for a GM cd radio but as mentioned it will have to be re-programmed by the dealer.

If it's an aftermarket cd player, you'll require a separate module harness with a relay circuit for the airbags and tach information to function. Or you can purchase a re-location kit which allows you to locate your factory radio into your trunk to hold those funtions. The re-location kit is a fair bit cheaper than the module. It's stupid that GM would design a system like that but that's what you'd need.

I am not sure about repairing the unit. Do you have a CD cleaner?
You might check with a reputable auto electronics shop, one that specializes in car audio. They may have an adapter that will allow an aftermarket radio to be controlled from the steering wheel. Rosen makes a nice am/fm/cd/dvd navigation unit that also has XM and iPod inputs. The hard part will be to find supporting interfaces and wiring harnesses to fit a 99.

If your installing a stock radio/cd player from another Dodge the wiring plug is the same and will fit.If your installing a aftermarket radio/cd player(JVC,Pioneer,etc)you will need to buy a adapter plug that wires up to the radio and is a direct fit to your factory wire harness,so your not cutting your wires.When you buy the adapter plug it comes with a wire diagram of which wire is what.Your aftermarket radio should have a diagram also,either on it or in the manual.Hope this helps you.