Fuel filter installation - 1996 Ford Explorer

NOTEThe fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cableFuel supply and pressure linesFuel filter bracket, if equippedFuel filter
   

To install:

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm)Fuel filter bracket, if equippedFuel supply and pressure linesNegative battery cable
   
2. Start the engine, check leaks and repair if necessary.

NOTEThe fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cableFuel supply and pressure linesFuel filter bracket, if equippedFuel filter
   

To install:

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm)Fuel filter bracket, if equippedFuel supply and pressure linesNegative battery cable
   
2. Start the engine, check leaks and repair if necessary.

NOTEThe fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cableFuel supply and pressure linesFuel filter bracket, if equippedFuel filter
   

To install:

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm)Fuel filter bracket, if equippedFuel supply and pressure linesNegative battery cable
   
2. Start the engine, check leaks and repair if necessary.

Back to Top

Sorry, there are no parts available for the selected vehicle: 2004 Hyundai Sonata 2.7L MFI DOHC 6cyl.

Removal & Installation

Print

NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket
   

To install:

1. Install or connect the following:
   
   Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
   
2. Start the engine and check for leaks.




Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models
Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models

NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket
   

To install:

1. Install or connect the following:
   
   Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
   
2. Start the engine and check for leaks.
   
   

   Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5 cylinder models
   Using an open end wrench to push the quick disconnect coupler sleeves back-5 cylinder models

NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.

1. Before servicing the vehicle, refer to the Precautions Section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket
   

To install:

1. Install or connect the following:
   
   Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
   
2. Start the engine and check for leaks.
   
   

   Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models
   Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models

On these models, the fuel filter is part of the fuel pump assembly. Refer to Fuel Pump removal and installation.

Yes, the 2002 LIncoln Town car has a fuel filter.

Fuel Filter Removal & Installation To Remove:

1. Place the vehicle on a lift.
2. Release the fuel system pressure.
3. Disconnect the negative battery cable.
4. Disconnect the fuel lines from the fuel filter CAUTION
   Some residual fuel will remain in the fuel filter after disconnecting the fuel tubes. Carefully drain the remaining fuel into a suitable container.
   
5. Remove the fuel filter.

To Install:

1. Install the filter in the bracket clamp.
2. Connect the fuel lines to the filter.
3. Connect the negative battery cable.
4. Pressurize the fuel system and inspect for leaks.

Fuel Filter Removal & Installation To Remove:
NOTE: There is no maintenance schedule for fuel filter replacement. Replace the fuel filter if restricted. Inspect the fuel tank internally if you find a restricted fuel filter.
Typical inline fuel filter

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Raise and safely support the vehicle.
4. Remove or disconnect the following:
   • Quick connect fitting at the fuel filter inlet
   • Fuel filter outlet fitting from the fuel filter while holding the filter fitting with a back-up wrench
   • Fuel filter from the vehicle
   • Fuel line O-ring.

To Install:

1. Position the new fuel filter in the bracket.
2. Install a new plastic retainer on the fuel inlet line.
3. Lubricate the new fuel pipe O-ring with clean engine oil.
4. Install the fuel pipe O-ring.
5. Reconnect the fuel outlet line to the filter by holding the filter with a back-up wrench and tightening the line fitting to 20 ft lbs (27 Nm).
6. Lower the vehicle.
7. Pressurize the fuel system and check for leaks.

Fuel Filter (behind gas tank) Removal & Installation To Remove:
NOTE: There is no maintenance schedule for fuel filter replacement. Replace the fuel filter if restricted. Inspect the fuel tank internally if you find a restricted fuel filter.
Typical inline fuel filter

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Raise and safely support the vehicle.
4. Remove or disconnect the following:
   • Quick connect fitting at the fuel filter inlet
   • Fuel filter outlet fitting from the fuel filter while holding the filter fitting with a back-up wrench
   • Fuel filter from the vehicle
   • Fuel line O-ring.

To Install:

1. Position the new fuel filter in the bracket.
2. Install a new plastic retainer on the fuel inlet line.
3. Lubricate the new fuel pipe O-ring with clean engine oil.
4. Install the fuel pipe O-ring.
5. Reconnect the fuel outlet line to the filter by holding the filter with a back-up wrench and tightening the line fitting to 20 ft lbs (27 Nm).
6. Lower the vehicle.
7. Pressurize the fuel system and check for leaks.

Fuel Filter Removal & Installation 2002-2004 To Remove:
NOTE: If a fuel filter is restricted, clean and inspect the inside of the fuel tank.

1. Relieve the pressure in the fuel system.
2. Lift the vehicle.
3. If necessary, remove the fuel tank shield from the frame.
4. Make sure the fuel pipe and hose connections, as well as the surrounding areas, are clean.
5. Disconnect the fuel pipes from the fuel filter; keep the retaining clips with the filter.
6. To avoid fuel loss and fuel system contamination, cap off the fuel pipes. Fuel filter removal and installation
   
   
7. Remove the screw from the fuel filter bracket.
8. Remove the fuel filter from the fuel filter bracket.

To Install:

1. Install the fuel filter into the fuel filter bracket.
2. For vehicles with a 4.2L engine, install the screw into the fuel filter bracket. Torque the screw to 13 in-lb (1.5 Nm).
3. For vehicles with a 5.3L engine, install the screw into the fuel filter bracket. Torque the screw to 106 in-lb (12 Nm).
4. Uncap the fuel pipes.
5. Connect the fuel pipes to the fuel filter.
6. Turn on the ignition for 2 seconds, with the engine off, and then turn off the ignition. After 10 seconds, turn the ignition back on with the engine off.
7. Check for leaks in the fuel lines.
8. Lift the vehicle.
9. If previously removed, install the fuel tank shield to the frame.
10. Lower the vehicle.

Fuel Pump-Mounted Filter

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
   
2. Properly relieve the fuel system pressure.
   
3. Remove or disconnect the following:
   
   • Negative battery cable
     
   • Fuel pump cover plate
     
   • Fuel lines from the fuel pump
     
4. Raise the fuel pump from the tank.
   
5. Remove the fuel filter assembly.
   

To install:

1. Install or connect the following:
   
   • Fuel filter to the fuel pump. Lower the pump assembly into position
     
   • Fuel lines
     
   • Negative battery cable
     
2. Start the vehicle, check for leaks and repair if necessary.
   
3. Install the fuel pump cover plate.
   

Inline Filter

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
   
2. Properly relieve the fuel system pressure.
   
3. Remove or disconnect the following:
   
   • Negative battery cable
     

Exploded view of an in line fuel filter and related components

Air intake hose and/or filter housing, if necessary

Fuel line clamps, if equipped

Fuel lines from the filter and plug the openings

Filter clamp bolt/nut by loosening them.

Fuel filter from its mounting bracket

NOTE Note the direction of the flow arrow on the filter so the replacement filter can be installed in the correct position.


To install:

1. Install or connect the following:
   
   • Fuel filter in its mounting bracket, making sure the flow arrow is pointing in the proper direction
     
   • Fuel lines to the fuel filter
     
   • Fuel line clamps, if equipped
     
   • Air intake hose and/or filter housing, if removed
     
   • Negative battery cable
     
2. Pressurize the fuel system and check all connections for leaks.
   

Fuel FIlter - Removal

1. Relieve fuel system pressure.
2. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

To install:

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.
   

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

To install:

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.

Fuel filter is incorporated in fuel pump assembly in fuel tank.

Hope this help.

2002 Hyundai Sonata 2.4L MFI DOHC 4cyl the Fuel Filter is located uUnder vehicle, driver side, below seating area, driver side of fuel tank, mounted on frame in fuel line.


Hyundai Car 1999-05 - Removal & Installation

NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

To install:



Fig. Remove the fuel filter

1. Install or connect the following:
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
2. Start the engine, check leaks and repair if necessary.
   

NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

To install:

1. Install or connect the following:
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
2. Start the engine, check leaks and repair if necessary.
   

NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

To install:

1. Install or connect the following:
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
2. Start the engine, check leaks and repair if necessary.

Hope this help to solve your problem.

1. Disconnect the battery ground cable.
2. Properly relieve the fuel system pressure.
3. Raise the vehicle on a hoist.
4. Remove the bolts and the fuel filter heat shield.
5. Remove the nuts and the fuel filter shield.
6. Disconnect the quick release and spring lock couplings and remove the fuel filter.
   

To install:

1. Remove any fuel line caps.
2. Install the new fuel filter, connecting the quick-release and spring-lock couplings.
3. Install the fuel filter shield.
4. Install the fuel filter heat shield. Torque the bolts to 15 ft. lbs. (20 Nm).
5. Reconnect the battery ground cable.
6. Lower the vehicle.
7. Start the vehicle, check for leaks and repair if necessary.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.