Oil light blinks and chimes when I come to stop. It stops blinking and chiming when I accelerate. I have changed the oil and know it is full.

Depress the accelerator pedal fully three times within five seconds. Allow the pedal to release fully after each pump. Listen for a chime, indicating the procedure is successful. The "Change Oil" light will turn off.. With the ignition key in ON, press the RESET
button located in the driver's side instrument panel
fuse block. See "Instrument Panel Fuse Block" in
the Index.
2. When the CHANGE OIL light starts to flash, press
and hold the RESET button again.
The reset is complete when you hear the chimes
sound and the CHANGE OIL light goes out.

As I remember, the first button press(s) step through lighting the change oil light, the tire pressure light and no light on the dash. Stop pressing while the change oil light is lit and then press and hold until the chimes.

do you have a low on oil sensor to.I know on Mercedes you sometimes have to change both.

I think it would start by having the battery load tested or if its the original battery it's probably due for replacement.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Is it the "brake"repair light blinking & chiming?? Or is it the "ABS" brake light blinking/chiming. Brake light should be red, ABS amber

it is possible your oil pump is going out, this is the reason for the chime

Hello Jw.

1. Turn the ignition to ON, with the engine off.
2. Fully press and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the CHANGE OIL light goes out. However, if the light stays on and no chime is heard, you will need to repeat the reset procedure.
3. Turn the key to OFF. If the CHANGE OIL light comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

There you are, thank you for using FixYa.

KL

in the fuse box is a reset button. turn ignition on but don't start vehicle , press and release the button oil change light should start blinking, press and hold the button until you here chimes or the light goes out.

REMOVE THE LEFT SIDE FUSE PANEL ON DRIVER SIDE.THE FUSE PANEL ON THE SIDE OF INSTRUMENT PANEL LOOK FOR A RED RESET BUTTON.WITH IGNITION SWITCH ON POSITION WITH ENGINE OFF.PRESS AND HOLD RESET BUTTON FOR 5 SECONDS.YOU HEAR A CHIME NOISE THE OIL SERVICE LIGHT WILL START BLINKING AND GO OUT THEN YOUR OIL SERVICE LIGHT IS RESET.

turn key on. wait for chime to stop. when chime stops, fully depress and release gas pedal 3 times quickly. start engine. light should be out. if not, repeat.

with the key in the on position, locate the reset button in the drivers side fuse panel,pess the button when the oil light blinks press again, should stop blinking and the chimes will stop, hope this helps