Both head light assemblies have been replaced because they where both foged up. Now the beems shinedown not out far enought. this is on a 2002 VW Passat How do I adjust the lights?

check the light control module
check/ replace head light switch

Open the back latch, look at the taillight housing you will either see regular phelps heads or York heads. Can you send me a picture.

someone has switched the wiring harness sockets to the wrong bulbs or installed the bulbs in reverse. get in behind the headlight assembly on the driver side and reverse the wires, if that does not work then pull the bulbs and swap them inside to outside and vice versa.

Open the hood, There will be some phillip head screws on the top of the headlight Assembly. After taking the screws out, the head light assembly will pull straight out. Replace bulb and replace assembly. Carefully to get the tabs on the assembly back into the slots when installing the assembly.

replace the bulbs.

you need to replace the bulbs. check all fuses under dash and under hood first.

It's just stuck...stick a smooth butter knife in between and pry outward carefully and don't rip the gasket that's making it stick.

You probably have the low side of your bulb blown check the bulb if that dont fix it ck your conector.if your dimmer switch was bad it wouldnt work on eather side. I will try to get you a diagram for the fuse box. PHIL.

You have to be careful-the whole assembly snaps in and out

check the continuity of the headlights to make sure there switching from the DTR Lights to the highbeams. If you are not getting the proper continuity check the ground wire for the low beams to ensure its properly grounded and has proper continuity throughout the wire. If not replace the wire or tighten as required and that should fix your problem.


lemme know if you require further assistance,

thanks - Nate