1986 dodge ramchager ignition cylinder and keys are locked in the run position. I have removed the stering wheel and signal light assembly and the three torex screws that attaches the sleeve that holds the ignition cylinder but it only moves a few centmeters. Is there a special release some where to get the cylinder out?
SOURCE: wheel bearing assembly 2004 dodge ram 1500
Hub & bearing should be one assy, is that what your looking at?
3 bolts behind hub, to remove, done?
SOURCE: remove tail light assembly
there are plastic clips on it just take your time and they will come out
SOURCE: I need to replace the connecting rod,cylinder
Your compressor is made by Porter Cable. You can use sears parts or takes your old parts to a local Dewalt service center and they will match them up with replacements. You can save some money on the bearing by using a generic. Universal bearing number will be found on the dust shield. Most likely the sears part numbers will be the same as porter cable. Dewalt service center will help you with other questions and or instructions. Good Luck!
159 views
Usually answered in minutes!
×