Cars & Trucks Logo
Posted on Nov 15, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

2001 Santa Fe Key fob Programming

Is it possible to program my 2001 Santa Fe Key fob without going to dealer and spending $42 for three minutes of work?

3 Answers

paul

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Champion:

An expert who has answered 200 questions.

  • Hyundai Expert 263 Answers
  • Posted on Nov 15, 2009
paul
Hyundai Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Champion:

An expert who has answered 200 questions.

Joined: Sep 22, 2009
Answers
263
Questions
0
Helped
102476
Points
549

Change the batteries then start the car and close it and press the key it should work

Harry Fitzgerald

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Sep 24, 2014
Harry Fitzgerald
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Sep 24, 2014
Answers
1
Questions
0
Helped
2190
Points
1

1 Find black box immediately behind fuse panel on left of panel under steering whee l. The black box approx. 5" x 3" has a "off/set" switch at the right rear of the box. May need to move wire harness to see.the switch.( It's easier to remove the knee pannel. First remove the interior dimmer control and housing by prying out with small blade screwdriver; then remove electric connection, set aside. Next remove three phillips screws and pull knee panel toward you).
2. Leave key out of ignition, it does not need to be on. Remove clear tape from "off/set" switch. Switch toggle to "set" with pick or small screwdriver.
3. Push "lock" on new remote(s) up to two. You will see little red led light on remote blink. You will hear nothing.
4. Move "off/set" toggl back to "off".
5. Test remote(s) It worked today 9/24/14 on my 2002 Santa Fe.
6. Replace knee panel and dimmer control unit.

Ad

diana

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Oct 14, 2013
diana
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Oct 14, 2013
Answers
2
Questions
1
Helped
2515
Points
2

Some a picser ofthe code po450

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2012 Hyundai Santa Fe. How to program key fob for it please?

Question edited for clarity and toss in some CAPS.
Question moved to model category.

There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Try a locksmith before the dealership, they are usually 50% the cost.
Mar 27, 2015

2012 Hyundai Santa Fe Key Fob Remote Programming ...


1helpful
1answer

2010 Hyundai Santa Fe Limited 3.5L where can i buy a remote fob without going to a dealer?

Hi Joe

eBay or Amazon, but the best bet is a local auto locksmith or a local alarm fitting shop in case it needs programming.

https://www.google.com/search?q=2010+Hyundai+Santa+Fe+Limited+3.5L+replacement+remote+fob

..
0helpful
1answer

4x4 diesel. Why can't doors be unlocked or locked?

their is a way to do it but recheck battery first sometimes the relearn process doesnt work or the fob itself is dead also if auto /remote start will need dealer to flash fob ---- 2002 santa fe and followed programming instructions and eventually was able to program the new remote. But, I did not realize I had to program my existing remote at the same time. Since, I have retried programming both remotes many times with no success--the new one works, but the old one won't. The instructions were: 1) Locate switch under dash, behind fuse box; 2) Turn ignition switch on, but don't start engine; 3) Wait 5 seconds, set memory switch to SET position; 4) Press remote LOCK button; press second remote transmitter LOCK button; 5) Set memory switch to OFF; 6) Switch ignition OFF. 7) Confirm programming by locking and unlocking vehicle.
Remote Key Programming Hyundai Forums Hyundai Forum
0helpful
2answers

How to program a keyless fob for 2001 cadillac deville

Unfortunately, the website I found says there is no on-board method of programming your car for a new key-fob. You have to take the car to a dealer or to a key-maker (who may only charge half as much as the dealer)

Key Fob Remote Programming Instructions 2001 Cadillac Deville Key Fob...
8helpful
2answers

How to program key fob for 2011 hyundai santa fe

Nonsense. I just programmed a new remote start fob on my 2011 Santa Fee limited and it worked just great. Follow the steps below and see what happens.
1. Open the drivers side door
2. Turn the Vehicle ignition to the ON position (Do not start the vehicle)
3. Locate the disarm/program button. (look closely, it is located on the wiring harness just inside the lower dash. it could be located just inside the fuse cover.)
4. Press and hold the disarm/programming button for 10 to 15 sewconds, the horm will beep 3 times. Release the disarm/programming button.
5. On the fob, press the Find/Panic button One time and the horn will beep one time.
6. Turn off vehicle ignition. (YOUR DONE)
0helpful
1answer

Need to program key fob for santa fe 2011

you have to take it to the dealer and get it programmed with there computer. there is no other way to do so. sorry
0helpful
1answer

Trying to re program my key fob

A special tool (electronic box) is required to program key fobs on early model Hyundai vehicles. Check with your nearest Hyundai Service Department & arrange for key fob programming/reprogramming.
4helpful
1answer

How do I reprogram the key fob on my 2005 Hyundai Santa Fe without having to pay the fee at the dealership?

Well, you basically have only 3 choices:
1. Pay the fee at the dealership
2. Purchase the high-dollar equipment that is required to perform the programming procedure
3. Forget about adding another key fob to tor vehicle.

TECHNICAL SERVICE BULLETIN

Group
90 - ELECTRICAL

Number
03-90-020

Date
October, 2003

Model
Elantra 2001-2004, Santa Fe 2001-2004, Sonata 2002-2004, Tiburon 2003-2004, XG(NNN) NNN-NNNNand XG(NNN) NNN-NNNN2004

Subject
SECURITY SYSTEM KEYLESS ADAPTER CABLE

This bulletin supersedes TSB # XXXXX
DESCRIPTION:
The security system keyless adapter cable (SPX/Kent-Moore P/N 09900-21300) is a special service tool (SST) that is used for programming new keyless entry remote transmitters to the factory security systems. The keyless adapter is used in conjunction with the Hi-Scan Pro (with Hi-Scan SOL Pro Software Version 09-29-03 or newer) and Data Link Connector (DLC) Cable.
SERVICE INFORMATION:
The keyless adapter cable can be used on the following vehicles:
^ 2001 -2004 Elantra
^ 2001-2004 SantaFe
^ 2002 - 2004 Sonata


0helpful
1answer
Not finding what you are looking for?

2,200 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...