I have a 99 ford windstar and the side back window on the drivers side is a pop out kind of window and where the arm attaches to the window it came loose. I know that it attaches with a screw on the arm and a rubber piece on the outside of the window. I lost the rubber piece. Could someone tell me the name of the piece that I am looking for so that I can order one. Thanks

SOURCE: 99 Ford Windstar Back door replacement

If I recall the wiring plugs in at the top you may be able to pull the plug with out droping the back of the headliner, But I am not sure, if not pull the two clips in the rear and one uper side panel for access. You will need someone to help yu remove the door. After you get the wiring loose at the roof and the washer hose, remove one nut/bolt out of each hinge at the door frame, and loosen the other two, remove the gas lift shocks by using a small screw driver to pry the clip back on the end that attaches to the door while some holds the door up, then remove the last two bolt/nuts in the door hinges, and remove the door. If you need to use parts on the old door like the lock cylinder yoou will need to remove the inner plastic panel to gain access to the clip that holds the cylinder. Replace in reverse order and adjust to fit properly before tightning the bolts at the hinges, then snap lift shocks back on and replug harness at roof and washer hose. Hope this helps.

SOURCE: 98 ford windstar. power windows, windshield wipers,willnot work,.

This sound like some type of relay switch failure in the fuse box, you need check all the fuses and see if they're all intact and make sure none of them are burned out. If all these are not working you have a live wire some where in you wire harness

SOURCE: The front driver side door's outside handle on my

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to everything. Either the bolts holding the outer handle on has broken or fallen out, or the handle anchor (plastic) has broken

Testimonial: "Great info. Thank you very much"

SOURCE: I remove the wiper arm & the outsdie lock of

IF YOU TALKING ABOUT REAR WIPER MOTOR REMOVAL YOU HAVE TO REMOVE PULL THE REAR WIPER ARM COVER BACK TO ACCESS THE WIPER ARM RETAINING NUT.DETACH THE NUT AND PULL WIPER ARM STRAIGHT OFF THE SHAFT TO REMOVE IT.

Hans Pearson

• 2510 Answers
• Posted on Apr 15, 2011

SOURCE: i need the rubber attachment

These are pretty universal and you should be able to get then at any spares shop, but the quality is not the same as the original equipment, so it might pay you to go to the agents.