Ho do remove the rear light in order to replace a burnt bulb? Dodge Grand Caravan 2005. Rear Right directional signal light not working, need help removing the cover lens. Thank you.

Have you checked the light bulbs?

The rear remove two push in pins remove tail light housing replace bulb. Front remove screws holding head light housing replace bulb

It's a ground issue

Most likely it sounds like a short. There may be (a) wire(s) grounding against the chasis.

Look inside under the steering wheel to the left,remove the lower steering column cover and knee pad panel to see junction box. The each fuse and relay will be marked for the right turn signal and the left turn signal. Look for a blown fuse on the left side. If not then the relay will be at fault. Before you start look to see if either turn signal lights are working on the left side. If the front is working and the rear is not then it will ba a short in the wiring to the rear causing the problem. Hope this will help you.

Bad bulb. When a turn signal bulb blows the other bulb on the same side will blink twice as fast since there is only half the load on the circuit. If the engine light came on at the same time the bulb blew then it probably meant that the computer notice the drop in resistance in the circuit and came on to let you know something is wrong. Change the bulb and have the engine code scanned/cleared. Autozone will scan and clear the code for free, except in Ca.

open the liftgate remove the screws holding the tail,stop,turn signal and back-up light assembly to the rear door opening. seperate the light assembly from the vehicle body. disengaging the hook holding the outer end of the light assembly to the body. swing the housing out to access the bulb holders. rotate bulb holder and remove blown out bulb. installation is the reverse of removal. hope this will help!!!

You may have used the wrong replacement bulb, check that

Rear turn signal bulb #3057
Plate Light bulbs #168