HOW TO CHANGE SPARK PLUGS IN 2007 HYUNDAI SANTE FE

Misfire , plugs , coil , etc ? Check engine light on or flashing ?

2001 Sante Fe Won't Start, Cranks But No Spark. - Hyundai Forums ...

www.hyundai-forums.com/...santa-fe/112601-2001-sante-fe-won-t-start-...
Jul 23, 2010 - 10 posts - ‎3 authors I have a 2001 Hyundai Sante Fe that died on me while driving down my street. ... Thecar has many other unrelated problems and I am not sure I want to ... may be causing my two cylinder no spark and alleged fuel problem? 2006 Santa Fe 2.4 Engine swap-no spark
10 posts
Sep 24, 2012
No Start 2.4L Engine 2004 Manual
10 posts
Nov 26, 2011
Good Crank/Have Fuel pressure/NO IGNITION
10 posts
Oct 9, 2011
Car Cranks But Will Not Start
10 posts
Jan 16, 2008
More results from www.hyundai-forums.com

Engine cranks but won't start.What should I do. - YouTube

? 9:37
https://www.youtube.com/watch?v=jsQcLya1YLQ
Jan 24, 2014 - Uploaded by jimthecarguy
No Start Cranks Ok No Injection Pulse 2002 Hyundai Accent Easy Step By Step ... and car cut off, but would not restart. it sounds like it is starving for fuel. ... hi nice video man . i have no sparkno fuel .u think its the main? it was ...

If you don't see anything on the radio saying "auxiliary output" with a little earphone jack then you aren't Aux ready.

You might be able to go to a stereo shop and have them install an auxiliary output plug. They will pull the factory stereo out and splice/plug in an output wire that you can plug your iPod into.

what size engine

Change spark plugs

You have to remove the intake plenum to access the spark plugs. That's the piece that sticks up and completely covers the back side when looking from the front. If you have fairly average car repair skills, it isn't all that hard but does take a lot longer than a normal spark plug change-out. If you remove the plenum and do this job yourself, you MUST replace the intake plenum gasket or you will end up with a bad vacuum leak. I strongly recommend you refer to a maintenance manual if you attempt this procedure. There is a lot of stuff attached to the plenum that has to be removed.

you have to take the upper intake off to get to the back plugs

Hope you changed plugs as well
When you had problem with coil,plugs will get damaged,and will malfuntion

rpm is regulated by the crank position sensor in all hyundai cars did one today

why would you fix a problem that is not there.if it is fine then enjoy it.plugleads only get changed if faulty.