Below is the diagram you requested. It's for a 3.3L with AC. If you need the diagram without AC, post back with the request and I'll track it down 4 you. Best of luck!
Greg
99 Caravan 3.3L Serpentine Belt
Hi there,
3.3L & 3.8L
To Remove:
Release the tensioner slowly once the belt is removed.
To Install:
** If this has helped you in any way, please rate this solution **
Here is the diagram you asked for
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
SOURCE: serpentine belt diagram:
The belt routing diagram is located on the top radiator cross member by the hood latch. You should see it when you open the hood. If it is not there, all Chrysler, Dodge, and Plymouth minivans, from 1993 to at least 1999, used the same 3.3L engine setup, so find someone with one and look for the diagram where I described.
SOURCE: Serpentine/drive belt routing diagram of a 2002 dodge Intrepid needed.
check dodge website you have to register to get the owners manual which has or if you have your owners manual
SOURCE: schematic belt diagram 2004 dodge sprinter 2500
search on internet, mercedes om 612 engine diagram
NOTE: When installing drive belt on the pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulley grooves. 1. Install the accessory drive belt (2) around all the pulleys except for the generator pulley (3). 2. Using a wrench, rotate accessory drive belt tensioner (8) counterclockwise until accessory drive belt (2) can be installed on the generator pulley (3). Release spring tension onto accessory drive belt (2).
3,408 views
Usually answered in minutes!
×