Fig. Tighten the valve cover bolts in sequence-1.6L and 1.8L engines
For 1.8L engines, tighten the bolts in sequence, as follows:
Step 1: Bolts 1-10 to 22 ft. lbs. (29 Nm).
Step 2: Bolts 1-10 to 43 ft. lbs. (59 Nm).
Step 3: Loosen bolts 1-10 completely.
Step 4: Bolts 1-10 to 22 ft. lbs. (29 Nm).
Step 5: Bolts 1-10 plus 50-55 degrees.
Step 5: Bolts 11-14 to 74 inch lbs. (8 Nm).
http://repairguide.autozone.com/znetrgs/...">
Fig. Cylinder head torque sequence-1.8L engine
http://repairguide.autozone.com/znetrgs/...">
Fig. Tighten the valve cover bolts in sequence-1.6L and 1.8L engines
×
Foot pounds (Final torque)
Note:
Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.
Foot pounds (Final torque)
Note:
Torque sequence --------- | 8 4 1 5 | | 7 3 2 6 | front --------- of engine | 6 2 3 7 | | 5 1 4 8 | Step 1: torque to 40 Ft/Lbs --------- Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.
3,091 views
Usually answered in minutes!
130ft-lbs (177NM) Good Luck, Shastalaker7
×