Door panel removal

Remove the door opening weather-strip. Refer to Door Opening Weatherstrip Replacement in Doors.
Remove side sill trim plate. Refer to Door Sill Plate Replacement in Interior Trim.
Remove the lower quarter panel trim. Refer to Rear Quarter Trim Panel Replacement in Interior Trim.
Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement in Interior Trim.
Remove the quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement in Interior Trim.
Remove the center pillar outer applique. Refer to Center Pillar Applique Replacement in Exterior Trim.
Remove the roof drip molding. Refer to Body Side Roof Drip Molding Replacement in Exterior Trim.

Important: It is necessary to use new nuts when reinstalling the quarter window.
Remove the nine quarter window nuts (1), securing the quarter window assembly (2) to the body opening.
Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
Important: When removing the quarter window from the body opening make sure that the attaching pins are clear of the outer body.
Remove the quarter window (2) from the body opening.

Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Remove the rear seat back. Refer to Rear Seat Back Replacement in Seats.
Remove the door sill plate. Refer to Door Sill Plate Replacement .

Remove the 3 quarter trim panel retaining screws (1).
Starting at the lower edge of the trim panel and moving alternately clockwise and counterclockwise, pull outward on the trim panel to disengage the eight rear quarter trim panel attaching clips (2).
Remove the quarter trim panel from the vehicle.
Remove the 4 radio speaker grille speed clips (1), securing the speaker grille.
Remove the speaker grille (2).
Remove the rear quarter trim panel insulator (1), from the back of the quarter trim assembly (2).
Remove 7 rear quarter trim panel armrest retaining clips (1).
Remove 7 rear quarter trim panel armrest retaining nuts (2).
Gently pry the quarter trim panel armrest insert assembly (3), away from the rear quarter trim panel and remove.

You mite look for a video on youtube !

Remove the inner door panel and make sure the actuator rod for the exterior handle is still engaged. If it is then the handle itself needs to be replaced.

Pull the vertical rods not the horizonal rods.

It could be the latch, but look to see if the interior door handle rod is still connected to the latch assembly. You will need to remove the interior door panel.

You will need to remove the interior door panel and inspect the linkages. The offending rod should be obvious and loose.

exterior panel is not removable. to access center roller,remove screws & clips from interior door trim panels remove roller cover panel inside door.loosen bolts to adjust roller,remove bolts to replace it.

Exterior Mirror Removal and Installation
All vehicles

1. NOTE: Left side exterior mirror shown, right side similar.
   Remove the interior door trim panel. For additional information, refer to Section 501-05 .

Front Door Trim Panel Removal and Installation

1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .

1. Remove the inside door handle bezel from the trim panel.

1. Remove the window switch assembly.

1. Disconnect the window switch and power door lock electrical connectors.

1. Remove the upper trim panel screw at the window switch opening.

1. Remove the lower trim panel screws.

1. CAUTION: To avoid damage to the door trim panel, do not pull directly outward for this step.
   Lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.

1. Disconnect the power mirror electrical connector.

1. Remove the trim panel.

1. Remove the weather shield.

Vehicles with power, heated or approach lamp equipped exterior mirrors

1. Disconnect the electrical connector.

All vehicles

1. Remove the bolts.

1. Remove the exterior rear view mirror (17682).

you can do this. you have to remove inside trim panel for access. if you still need to do, I will send you repair steps. let me know

The molding in the middle of the door clips on. Remove interior door panel to access the clips, they usually break off. Or do you mean the black tapes (stickers) around the window opening, they are just stickers. Take a heat gun to loosen glue and peel off.

First unscrew all the screw on the door then remove interior panels gently with screw driver and open the protective plastic film then remove all the wirings from the car and then remove the bolt from the car body and fit new door and make the wiring should be plug to car door as earlier...................