2001 Kia sportage starter location?
SOURCE: Starter for kia sportage 2000
Negative battery cable
Intake manifold bracket upper bolts
Clutch release cylinder and move it aside, if equipped
Intake manifold bracket lower bolts and remove the bracket
Starter from the clutch, manual transmissions only
Starter from the torque converter, automatic transmissions only
Starter electrical connectors
Move the transmission wire harness aside
Starter
Fig. Exploded view of the starter
To install:
Starter to the engine well
Starter electrical connectors
Lower intake manifold bracket and install the upper bolts
Starter into position. When aligned properly torque the bolts to 40 ft. lbs. (54 Nm).
Torque the intake manifold bracket bolts to 40 ft. lbs. (54 Nm).
Properly position the clutch release cylinder, if equipped. Torque the bolts to 40 ft. lbs. (54 Nm).
Torque the intake manifold bracket upper bolts to 40 ft. lbs. (54 Nm).
Negative battery cable
SOURCE: 2001 kia sportage blower motor resister
Rule of thumb...unless you get a better answer: look for a couple of wires on a small plate that is in the airflow of the fan on the heater/ac unit. The resistor pack is always air cooled by the fan.
908 views
Usually answered in minutes!
×