1997 Jaguar XK8 Logo

Related Topics:

Posted on Nov 11, 2009

97 jaguar xk8 starts then stalls

97 jaguar xk8. Used to run good. One morning started, but stalled after a couple of seconds. Cranked good but did not fire up. If a step on the gas pedal a couple of times or open the trottle blade, the car will start, but start sputtering and shakeing and stall. Codes P1000 pending and P1643

  • Jay Smith
    Jay Smith May 26, 2015

    Ever find a solution? I'm having same problem

×

5 Related Answers

bobvallom

  • 5 Answers
  • Posted on Nov 24, 2008

SOURCE: Adding coolant to a 1998 Jaguar XK8

if the coolant light is on or comes on when driving you MUST let the car cool down at lest 1 hour before doing anything, after this cool down time lift the hood [u.s.a.] or bonnet [uk] looking from the front of the car on the right hand side towards the back of the engine compartment is the coolant header tank,about 5inch square black in color [u.s.a.] colour [uk] with a large screw top and some rubber pipes coming from it,this should be topped up with coolant right to the neck of the screw cap when you remove the cap to top up the coolant unscrew it slowly as it may be under pressure you don't want hot 212F[u.s.a.] 100C [uk] coolant in your face do you.good luck.

Ad

Anonymous

  • 16 Answers
  • Posted on Jan 30, 2009

SOURCE: need to install radio antenna on 1999 jaguar xk8

on the base of the antenna mast is a chrome nut (14mm?) unsrew that, then turn radio on , it will eject the guide cable. then insert the new cable, turn radio off and wait like 15sec then the motor will take in the new cable then put the chrome nut back on> thats it

Anonymous

  • 1 Answer
  • Posted on Apr 22, 2009

SOURCE: failsafe engine mode light comes on, codes

Just a quick mention - for about a month my XK8 low coolant light came on intermittently. This week with no notice while driving normally I got Stability Control Fail and FailSafe Engine Mode and wtih great difficulty got the car back to where I started from (less than a mile). Two days later (when got time) and after a bit of research, I tried it again - same problem and a very unhappy engine. I then disconnected the battery for 15 minutes (probably more) to clear the engine codes as well as check all the wiring and vacuum stuff I could under the hood (at a Jaguar master mechanic's recommendation). No problems found but the car would start and immediately stall with the air intake hose disconnected from the intake butterfly. After I reconnected the air intake hose, she started and purred like normal. The problem is the BATTERY... It is low - I've known it for a LONG time BUT it always started right up and never skipped a beat. I intend to replace it tonight but fully expect that's the issue. I've had the car 6 years (it's a 98) and had NO problems except a dead taillight asembly.

Hope this is of value...

Anonymous

  • 4 Answers
  • Posted on Apr 26, 2009

SOURCE: i want to clear check engine light on 2002 jaguar xk8

go to autozone have them scan it and then clear it record the trouble code and then clear it another option is disconnect the battery both positive and negative and make a jumper wire between the 2 terminals make sure that you disconect the battery very importan

Anonymous

  • 2 Answers
  • Posted on Jul 27, 2009

SOURCE: jaguar XK8 PROBLEM BOOT WON'T CLOSE

In the trunk on the right side behind the carpet is the hyrdaulic unit. There is a T fitting on it. Turn the T fitting counterclockwise to release pressure. Tighten it back up and try the top again. I have had this work for me several times.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My xj8 Jaguar crank up and sets right back off what all could be wrong

Security is set. Could be one problem. Fuel system can do this, but rarely. Takes a scanner to see where to look first.
0helpful
1answer

Stalls when in drive

idle control system U/S
0helpful
1answer

My 97 intrepid will start up, but putter out within seconds

Map Sensor or Crank Sensor. If you have a code reader the map sensor should throw a code, the crank sensor most often will not. Both will cause the car to start, idle to around 1,000 R's and then die.
0helpful
2answers

1989 Jaguar Vanden Plas. Stalling on longer journeys

Fuel pump...change the fuel filter at the same time....
1helpful
1answer

Engine stalls

ok, the problem is rich gas in exhaust,check the air filter,fuel pressure regulator, or maf sensor
0helpful
2answers

Jaguar stalls

If this is the same as the problem of engine stall when reaching 60 - 80 mph (and then usually taking foot of accelerator).
Then it is probably due to a fault in the circuitry in the throttle body. some were replaced by Jaguar but now I believe you need to get a new one (now rectified versions) - about £800
Hope this helps   Chris 
0helpful
1answer

97' accord, stalled on wife while driving? 5 min. later it started and stalled on it's own again. cranked it once more and she drove it home. now a couple of days later the car runs fine but the check

Your best investment is a Haynes Repair Manual, either from your local Auto Zone or similiar retailer or online: http://www.haynes.com/products/searchType/vehicleApplicationSearch2/searchEnd/yes/sfID1//sfID2//sfID3//year/1997/make/Honda/model/Accord/x/20/y/3/productID/193. Step by step instructions on troubleshooting, repair or replacement, based on a complete teardown and rebuild.
Not finding what you are looking for?

618 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...