Question about 1991 Oldsmobile Ninety Eight Regency

1 Answer

91 Olds 98 Regency elite once in a while the car doesn't start. The starter fires but the engine doesn't turn on. If i wait 10 minutes or so, it starts.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Oldsmobile Master
  • 426 Answers

Based on the information you have given to this point, I am just going to give you a few possiblities. Have you had a tune up done recently? Air filter been checked or changed? I am not in any way trying to sound sarcastic so I apologize if I come off that way.Those would be my first things to inspect if I were ask to look at your car. I would also check fuel pressure and inspect the fuel pressure regulator.I would consider these things and go from there. I Hope this helps you but please let me know if you need more information on what to do next but I may need some more information at that time also .

Posted on Nov 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 95 oldsmobile 98 regency elite I cant find where the knock sensor goes I have a haynes manual but where it shows it wont go


Well, for starters, your problem got posted under 1985 Oldsmobile 98 - then you said it was a 95 Oldsmobile 98 Regency Elite (HUGE difference between 85 and 95)...then it would be REALLY nice to know which engine we are talking about.

I'll just go with what you said last: 1995 Oldsmobile Regency Elite (Two engine possibilities)

If you have the 3.8L Supercharged engine (VIN CODE "1") it is on the left side of the engine near the oil filter.

If you have the non-supercharged 3.8L (VIN CODE "K") there are TWO of them. One is near the oil filter and the other one is in about the same location on the other side of the engine block.

Please also note that MOST fault codes for knock sensors are not caused by the knock sensors themselves. (they do fail, but it is very rare.) Usually there is either a wiring problem to the knock sensor, or the engine has internal problems causing a "knocking" or "ticking" noise which causes the engine computer to "think" that there is a problem with pre-detonation causing an "ignition ping". The code sets when the computer has retarded the ignition timing as far as it can and the "knock" or "ping" does not go away....usually it doesn't go away because it is not caused by ignition timing. The knock sensor is just doing its job and reporting the knock. It does not know the difference between a knock caused by ignition and a knock caused by internal engine problems.

Jun 28, 2011 | 1985 Oldsmobile 98

1 Answer

92 olds 98 regency wont turn over wont do anything


If you have no power at all when you turn the key on try changing your battery.If you have power and the starter isn't engaging remove your starter and have it tested to see if is bad.Most of your local auto parts stores do this for free.

Mar 08, 2011 | 1992 Oldsmobile Ninety Eight Regency

1 Answer

1995 Olds 98 Regency Elite I'm re-attaching rear


there is a small set screw in the base of the mirror you will need to loosen this and then slide the metal plate out.

Aug 30, 2010 | 1995 Oldsmobile Ninety Eight Regency

1 Answer

Where is the starter in my 95 olds regency 98


The starter is near the bottom rear of the engine. Just follow the large (red) cable from the battery.

Bill B

Aug 19, 2010 | 1995 Oldsmobile Ninety Eight Regency

2 Answers

Fuse box diagram for 1990 olds 98 i want to cut


Review this Wiring Schematic about Olds 98 ('89, '90 & '91):
1989 1
1989 2

1990 1
1990 2

1991 1
1991 2

I really hope help you with this (remember rated this help). Good luck.

Oct 21, 2009 | 1991 Oldsmobile Ninety Eight Regency

2 Answers

1991 Olds 98 regency elite not start


iv'e had the same problem. mine was the starter wire had a split in the wire under the plastic. i cut wire and wired it directly to the bolt.

Jun 03, 2009 | 1991 Oldsmobile Ninety Eight Regency

1 Answer

1995 Old 98 Regency elite with3.8 v6


have the crankshaft positioning sensor checked out

Jul 15, 2008 | 1995 Oldsmobile Ninety Eight

Not finding what you are looking for?
Cars & Trucks Logo

435 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...