Need location of inner belt tensioner for '05 Kia Sedona

Kia Sedona Car & Truck Interior Consoles & Parts ' eBay

www.ebay.com/sch/Kia-Sedona-Car-Truck...Consoles.../i.html
eBayShop from the world's largest selection and best deals for Kia Sedona Car & Truck ...2002 2003 2004 2005 KIA SEDONA CENTER CONSOLE FOLDING TRAY TAN ....Overhead Console 02-05 Kia Sedona with Map Lights Clock and Storage ...

Center Console Removal - '05 Sedona - Kia Forum

www.kia-forums.com/...sedona.../30338-center-console-removal-05-sed...
Nov 11, 2005 - 5 posts - ‎4 authors I need to remove the center console in my 2005 Sedona so I can remove the stereo. ... address lol) so I have to pull the stereo and probably replace it. .... the right side of the pannel, as well as the hazard switch at the top of the ...

left side of exaust after catalictic converter

I hope this diagram helps.

The oil filter is located behind the right (passenger) inner fender cover. It is right next to the crankshaft pulley at the bottom-------------------------------------------------------------------------------
Car Diagnostic Tools

By the camshaft reluctor wheel on the front of the engine by the belt side. Should be one bolt and a wire plug.

At the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump

The kia sedona water pump is an internal pump and needs to be replaced with timing belt service. if it is leaking, then you need to change the timing belt as well. probably not something you want to do in the back yard and will run you between 400 and 600 depending on your location and shop.
Visit my Blog

Click on the following free, direct Link. It has the Serpentine Belt Diagrams you will need.

http://www.2carpros.com/car_repair_information/year/2005/make/kia/model/sedona/2005_kia_sedona_drive_belt_routing_diagram.htm

On the Serpentine Belt: Scroll down the Link Page to Diagram G00323207, it shows the Tensioner.
1. Loosen the Pulley Lock Nut - identified as "A"
2. Loosen the Adjustment Bolt - identified as "B"
3. The Tensioner Pulley should move up and slightly to the left, loosening the belt enough to remove.

Installation is the reverse of the above.
Note on Diagram G00323206 the deflection tolerance at the 22 lbs pressure on the belt.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

There is a tensioner pulley that has a nut in the middle of it, loosen that nut and there is a tensioner bolt that when you loosen it, it slides the pulley away from the belt to replace it.

2005 kia sedona ecu is located on passenger floor under carpet. After you remove the carpet half way, there is a silver plate you have to remove with 10mm deep well socket. there are 4 connector plugs.