- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Get a second opion, but it looks like the thrust bearing is on its way out. That'll probably involve changing the clutch as well. Do it soon or you'll wreck the gearbox.
Most likely to be a faulty resistor block, which has 3 resistors and a thermal fuse controlling fan speeds 1,2 and 3, maximum speed 4 by-passes the resister block. It may also be poor electrical connections to the resistor block caused by overheating. Renault ask for approximately £350 to carry out repairs, a replacement resistor block will cost £50. If you decide to carry out the repairs yourself, be advised that if you are not competent to carry out such work you, could cause electrical damage or worse an electrical fire.
hi mate,just bought my mum one with the same prob..drop down the rear seats,spray some wd40 into the black latch cover on the latch inside,work the central locking locking a few times untill it frees,when open remove latch and clean to ensure no further siezing,regards craig
It is a fiddle but drop the l/h side of the subframe down, pull the shafts, jack the engine a bit and seperate the box and you can just unbolt the cover plate, slide it back and lift out the centre plate, then the cover plate comes out, you have to align the new ones by feeling the alignment in the 3 gaps round the edge, fiddly but save a heap of time
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls
×