At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
this is because its not fully shifting back into 2 Hi. make sure vehicle is in neutral and idling, push the 4 Low button listen for a shifting sound or whirring noise. then push 2 Hi button. it flashes while it is attempting to shift you should hear a shifting clunk or whirring noise, then the light will stay lit. after shifting from 2 wheel drive to 4 wheel drive shift into reverse before selecting drive on the column. the rpm going so high is because your vehicle is still in 4 wheel drive. the low gearing results in high rpm. if it does not shift into 2 wheel drive : there is a shift actuator on the transfer case, check the cable connected to it. this cable is connected to the vacuum control pump deal that controls you cruise control. this pump is located directly under the battery box. the plate the battery sits on must be removed in order to see it. check any wiring there and check for vacuum leaks in the lines connected to it . this pump actually pulls on the cable going to the shift actuator. check that the cable is attached and the baffle on the pump is moving. you can manually pull the cable by hand, while having an assistant operate the buttons inside the cab. this will release the actuator in the transfer case allowing the transfer case to shift properly. basically its a locking mechanism, locking the transfer case in the selected gear range. it must actuate in order to complete the shift
2 speed electric shift transfer case problems #1 jack up truck place on 4 jack stands. Start and select 4 high position in drive release brake ad watch front driveshaft does it turn "yes" problem is axle actuator on passenger side of differential not engaging axle shaft. "no" apply brakes bring to a stop engage low range does low range work "yes" internal transfer case problems "no" electric transfer case shifting motor failure.
Sometimes the solenoids will stick on the axle neither in 2 or 4 wheel drive, if this problem started when you weren't shifting between two and four wheel drive it is probably the push button switch cluster on your dash going bad
Have you tried putting it in Neutral, then selecting 4-low. That's what we have to do on our 2000 Chevy Blazer. Same with going from 4-low to 4-high or 4-low to 2 high. It will shift from 2-high to 4 high on the fly (not in Neutral) and back.
the most likely cause is the front axle shift motor if bad your your front axle shaft will not lock in.if there is no shifting of transfer case there is also a electric motor that engages that in .
hey there i cant tell you what you are missing but i can tell you how to disengage the front wheels . ok you have a vacum line that runs right under the battery and a line that comes up from the front diff. to the same place ( you may have to remove batt and batt tray to get full access to this) un bolt it and temporaly put batt and batt tray back in start it up and decompress this and see if it comes out .... you should here clunking noise if it goes back in ... if thats the case just pull that big vaccum line off .... to test get all four tires off the ground and have some one put it in drive but dont hit the gas it should turn on its own ...if that dont work check the cable that runs down to the differental
×