Directionals periodically dont work checked the wire conections and swapped out the directional modual with the hazards light that is mounted on the steering column

The direction indicators are unlikely to work correctly until the hazard light switch functions correctly - the hazard switch is usually wired so when operated it has cut the direction indicator wiring and connected itself to the lamps rendering the direction indicator switch redundant.

Lots of cars suffer indicator problems when the hazard switch is rarely used. Often a few minutes vigorously operating the hazard switch restores operation but if the switch is broken it must first be replaced.

Disconnect the Battery and Charge it as a STAND ALONE CHARGE (not connected to the car), You may have a bad ECU.

Seems like you have a electrical problem. You may have wiring problem

Usually not. Both are on separate circuits. Directionals are only on when the key is in the on position, Hazards are on (hot) all the time. If I remember correctly, they both share a common junction though as they pass through the directional switch in the top of the steering column. You will need to do some testing: fuses, and wiring to trace power. Also check power at the flasher sockets. If you just bought it, be aware that a common "on the road fix" for a bad directional flasher is to swap it with the one for the hazards. In that case, when the directional flasher that was swapped fails, both would in fact test as bad.

H).l-blu wire connect to left front turn signal J).dk-blu wire connect to right front turn signals K).brown wire connect to hazard/flasher relay output L).purple wire conect to turn/flasher signal M). yellow wire connect to left rear stop hazard light N). dk-green wire connect to right rear stop/hazard light P) white wire connect to stop light swirch output

The hazard flasher is a separate flasher by itself for the directional has its own. The brake lights work off the brake light switch mounted by the brake pedal

You have a bad turn signal switch if the hazards work and the turn signals do not. It has nothing to do with the fuse or the flasher unit. Your switch is bad or you have a bad connection some where.

Relays buzz when they are not getting enough power either due to a power wire with a high resistance in it or a ground with the same problem,check the harness manually to see if you can find a loose or corroded conecter or ground point.

TEST FRONT RIGHT BLINKER CIRCUIT AND REPLACE THE BULB,,WITH PROPER BULB...A DOUBLE CIRCUIT BULB IN A SINGLE SOCKET WILL DO THAT ALSO A SINGLE SOCKET BULB IN A DOUBLE SOCKET HOLDER....CHECK LEFT SIDE BULB FOR ACURANCY

it sounds like you have a major electrical problem check all the fuses and look for any burned wires under the hood