How to remove rear door panels on a 2003 ford f 250to get to door switch

Tailgate latch, handle and lock

• Open the tailgate.
• Remove the two bolts and detach the door stop.
• Lower the tailgate and remove the tailgate access cover.
• Disconnect the control rods.
• Detach the retaining nuts and remove the handle and lock cylinder assembly from the tailgate.

• Disconnect the cable(s) from the negative battery terminal(s).
• On manual window equipped models, pull the window crank cover aside, remove the screw and detach the handle.
• On the front door of power window equipped models Pry up on the retaining clip at the front edge of the armrest and lift the armrest switch control plate out and disconnect the electrical connections,then remove the retaining bolt from the opening.
• Use a small screwdriver to pry off the courtesy light cover for access to the trim panel retaining bolt.
• Carefully pry off the mirror trim panel from above the front edge of the door panel.
• Once all of the bolts are removed, remove the trim panel by gently pullingit up and out .Detach the courtesy light bulb housing from the panel.
• For access to the inner door components, remove the speaker (if it would interfere with watershield removal) and the screws from the trim piece at the lower trailing corner of the door, then carefully peel the watershield from the door.
• Remove the screws securing the latch.
• Working through the large access hole, position the latch as necessary to disconnect the electrical connector and disengage the outside door handle and outside lock cylinder to latch rods and the inside handle-to-Iatch cable.
• Detach the locking rods by unsnapping The remaining outside handle retaining nut can be reached through the access hole in the door frame and the upper striker the portionof the plastic clip engaging the connecting rod, then pulling the rod out of its locating hole.
• Position the latch as necessary to disengage the door lock actuator hook. Detach the cable cover and disconnect the cable from the latch. Remove the latch assembly from the door.