SECTION 501-09: Rear View Mirrors
2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION
Exterior Mirror
Removal and Installation
Front Door Trim Panel —Expedition
Removal and Installation
NOTE: Left front door shown, right front similar.
Remove the two bolts and three screws, and remove the door trim panel.
---
Exterior Mirror Motor
Removal and Installation
SOURCE: i need to replace passenger side mirror on 97 ford expedition
You probably don't need to pull the door panel. On the outside of the mirror is a plastic trim cover. Use a trim stick to remove it to allow access to the screws holding the mirror in. Don't unhook them yet. On the inside, remove the plastic trim over the door/windshield pillar - first removing any grab handles that may be there. You don't say if this is a power mirror. If not, then that should do it. If it is, you may need to lift the dash cover up slightly with the trim stick to gain access to any electrical hookups.
Trim stick = soft tool for use in removing plastic pieces without messing them up.
SOURCE: REPLACE FORD TAURUS WAGON DRIVER SIDE MIRROR
you have to take the door panels off. remove all screws you will have plastic pieces called christmas trees that hold the panel in place. there is a tool for this you can pick it up at Napa for cheap this will allow you access to the inner space of the door un plug plugs to power switchs and the rod to your door catch hardeware you then can remove panel completely to get access to mirror assembly. installation of door panel is in reverse
SOURCE: how to replace the light bulb on exterior mirror 2003 ford expedition
The one with the turnsignal intergrated into it?
If so.....
Push the Mirror FORWARD, up close to the pivot poit there is a small torx head screw - unscrew that.
At the tapered end carefully pull/pry down. That end has a small metal spring clip that holds it up, be careful with it, if it snaps, you can NOT by a new one...
SOURCE: How to replace just the glass on my side mirror
Go to any glass shop, they'll cut a new mirror and glue it on top of the old one. Much cheaper than replacing the whole unit (hundreds).
SOURCE: how to install passenger side view mirror Ford
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
1,861 views
Usually answered in minutes!
×