Where is the PCM located on a 2002 chrysler sebring?

Should be under the dash on passenger side. It might be behind the kick-panel.
Sometimes I look under the hood at the firewall, passenger side, if a bunch of wires going through firewall, that's the wires going to pcm.

Have your battery tested and make sure the battery cables are clean and free of corrosion.

its in the alternator, the pcm is right behind the drivers headlight, its rectangular and has two large electrical connectors

The starter is located on the front of the engine, right above the front motor mount and between the catalytic converter and the engine block.

my temperature gauge on A 2002 sebring keeps going up and down when I'm driving what causes that?

P1193 = "Inlet Air Temp. Circuit High". The PCM apparently sees too much voltage from the inlet air temperature sensor. I suspect this sensor is in the rubber ducting to the throttle body, or possibly in the intake manifold. Check that the connector is firmly attached and that the wiring to the connector is intact - no breaks or fraying.

On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).



Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models



Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block



Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

should be at the right rear of engine block just ahead of the transmission

THIS COMMUNICATION FAILURE COULD BE AS SIMPLE AS A BLOWN FUSE UNDER THE DASHBOARD, OR UNDER THE HOOD. CHECK IT OUT. HOPE THIS HELPS. THANKS IN ADVANCE FOR AN HONEST RATING. AND FOR USING FIX-YA. BEST OF LUCK

fuel filters are usually located under the driver side of the car. it will be a metal cylinder with 2 lines on it. one going to the engine and one coming from the gas tank.