2004 Audi A4 Logo

Related Topics:

Posted on Oct 26, 2017
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Loss of power when under 2000rpm wont accelerate unless I give it high revs. no fault codes being shown and engine man light has now gone off/ reset - still have problem - will run happy with lots of power once above 2000rpm in fifth and sixth gear but will splutter and cough out smoke when revs drop lower than 2000rpm. Idles fine no prob ?

  • Anonymous May 11, 2010

    Which engine do you have, a 6 cylinder or the 4-cyl turbo?

×

1 Answer

Jeffrey Turcotte

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Audi Master 8,991 Answers
  • Posted on Oct 26, 2017
Jeffrey Turcotte
Audi Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Aug 22, 2010
Answers
8991
Questions
7
Helped
4372251
Points
33683

5 Related Answers

kraut64

  • 15 Answers
  • Posted on Aug 18, 2008

SOURCE: Engine warms up and idles at 2000RPM

If you checked as suggested for vaccum leaks and have no improvement or only little... Assuming here its KE-Jetronics fuel injection.... on the excellerator linkage is a microswitch that gets activated when the excellerator hits idle position (decel fuel shutoff)... it has an influence on your idle quality, also the electronic component in your air/fuel mixture body (Airflow potentiometer) could be the 'guilty' party aswell as your Idle valve (on single belt engines) that is stuck between the inlet pipe of number 3 and number 4.12001b5.jpg Anyway i hope this helps to locate the problem

Ad

Anonymous

  • 68 Answers
  • Posted on Nov 28, 2008

SOURCE: Engine stops while driving & engine revs high between gear change

hi i am dieter
im dave

here is something to try
keep some cold water with you and the next time it happens very quickly get out and pour the water on the crankshaft sensor then restart. If it starts right away without the usual two minutes than you will need to change this sensor. The sensor is easy to find you will see a wiring harness around the crankshaft pulley(the large one at the bottom the basically runs all your accessories like the p/s pump, alternator, water pump). Try to famaliarize yourself as to the location of the sensor first so that you can try to restart it within about 30 seconds.

Anonymous

  • 6 Answers
  • Posted on Nov 29, 2008

SOURCE: no acceleration,audi 1.8t,runs like no boost

have you tried cleaning out the throttle body as i had a similar problem and this worked

Anonymous

  • 2 Answers
  • Posted on Feb 24, 2009

SOURCE: Audi Quattro A4 2002 "Check engine oil warning lamp"

take it to an audi mechanic and reprogram the computer. it cost around $35 dollars.

Anonymous

  • 62 Answers
  • Posted on Jan 27, 2010

SOURCE: Hyundai sonata 2000 cdx 2001 auto> The car

Sounds like you have a plugged up catalytic converter. You cant clean them it will need replaced. If it is the 4cyl engine, the converter is the exhaust manifold on the front of the engine.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2004 Kia Rio idle air control valve had a hair line fracture replaced it with a new one, now when you give the accelerator a quick rev and remove your foot off the accelerator the rpm stays high for about...

That valve is going to have to be calibrated to 1100 RPM with the air on........You may be able to open a cover and adjust the pentle.. the Hondas you lightly bottom them then back off about 1/16th of an inch turn.....
0helpful
1answer

Loss of power on acceleration & hills no warning lights showing

Have the codes read anyway. Turn the key on, do you see a check engine light? We work on auction cars also. To many times I see that the light is not on.
0helpful
1answer

Engine wont rev above 2000rpm

If you have a hih miles truck,it is very possoble you have aclogged cat.Have a muffler shop test pressure in front and behind by drilling small holes,checkin w/gauge,then welding back.This should be free if you replace the cat.
0helpful
1answer

Loss of power

have the fault codes read
indicates accelerator position or throttle position sensor problems
1helpful
1answer

POWER LOSS ON 98 TAHOE

even though you may have had a intermittent issue check the pcm there may be a code that will help you when/if this happens again
0helpful
1answer

Help please, my vw golf 1.6 sr is loosing mad power. it wont accelerate properly and the revs arent going past bout 2000rpm, rev counter sits below 0 when idling?? it takes ages to even get up to 30

IF YOU SEE CHECK ENGINE LIGHT FLASHING LOOK FOR TURBOCHARGER WASTEGATE REGULATOR VALVE FAULT OR MAP SENSOR FAULT.THAT COULD BE YOUR PROBLEM.IF NO CHECK ENGINE LIGHT FLASHING YOU COULD HAVE A RESTRICTED EXHAUST SYSTEM BAD TURBOCHARGER, RESTRICTED FUEL FILTER.ALL THOSE THINGS WILL CAUSE POWER LOST.
0helpful
1answer

TCS warning light is on. Check engine light is on. Reduced engine power light is on. the accelerator wont work when pressed all the time. when revving it up it will not rev over 3k in neutral.

There are literally thousands of codes that can cause the check engine light to come on. There is no way to guess why yours is on based on your symptoms. Many auto part stores will scan your engine computer and give you a print out of the codes for free, unless you live in CA. We would need to know what these codes are to give you an accurate reason you are having issues. FYI, modern engines won't rev past 3000-3500 rpm in neutral. This is to prevent engine and torque converter damage.
12helpful
1answer

Jag xtype 2.0D 2004 Glow plug light flashing.Engine malfunction light on .No loss of power.Hhappened just after refuelling

jaguar x-type 2ltr diesel 2004 the glow plug warning light flashing, was told dirty fuel on fault code all fuel changed and filters. No problems for 20 miles untill engine was put under power on high revs went into limp mode, warning light glow plug falshing again? any ideas thanks.
0helpful
1answer

Engine code giving misfire on 4 o 5 and P1521 oil contamination

check cam sensor,if the timing isn't adjusting with acceleration then you would have noticable power loss
6helpful
2answers

Fault Code : P1664

P1664 FIP (Fuel Injection Pump) malfunction (possible air ingress in low pressure fuel side)
Most likey the Diesel fuel injection pump needs to be replaced or overhauled.
Not finding what you are looking for?

1,136 views

Ask a Question

Usually answered in minutes!

Top Audi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...