Rear brake and turning lights will not work. Bulbs are good but lights won't work.

Well the brake light and turn signal circuits are on two different fuses, but they both go thru the turn signal switch.
So I would start by checking for power in and out of the turn signal switch for each circuit.

Check the brake fuse in your dash's fusebox. Since the turns work, you know the bulbs are good, unless your Neon has separate brake lights. If the fuse is good, bulbs are good, then check for power at the brake light switch on the upper portion of the brake pedal. Should have 12 volts there all the time. Use a testlight or voltmeter to check. Good luck.

Replace the circuit board on the left rear tail light ***.This can be purchased at a NAPA auto parts store.(this is where the bulbs are fasten into)

check the brake light switch on the brake pedal for the third brake light staying on. check the bulbs in the rear of the car for the lights not working.if the bulbs are good then check for power to the light sockets.

I would scan for BCM errors, you could have caused a voltage spike.

• If there are no brake lights period the check the stop switch (brake light switch)
• This is attached to the upper part of the brake pedal itself. Should be a little wire off of it. When that goes bad the brake lights will not work at all.
• Please note that the fuse for "brakes" is ABS only and has no bearing on the brake lights themselves working.

Regards, Tony

See if bulbs have burnt out in the left brake light and rear turn signal (one bulb if combined) and also rear center high mount brake light.

If the left turn signal has a slower speed than the right turn signal, this is a symptom of a bulb or bulbs burnt out.

Usually, the wiring is not a problem, but I would not rule wiring (or sockets) as a problem out.

Good luck on this repair.

CHECK TAIL LIGHT BULBS.IF BULBS CHECK OUT GOOD PROBLEM COULD BE CORRODED BULB SOCKETS OR BROKEN LOOSE WIRE IN CIRCUIT.

check the rear lower bulbs, if good nore than likely brake lamp switrch on brake pedal, 3rd lamp rns of separate circuit

the brake lights and the rear turn signals should be the same bulb check the bulbs to make sure they are not blown does your third brake light work if all brake light are out and the bulbs are good check the brake light switch on the brake pedal