Why do my doors on my 2006 jeep cherokee grand laredo keep locking and unlocking? This problem is draining my battery.

Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.

Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.

Sponsored Links

• Remote Control Software

  Control any distant PC remotely. Test the Software now for Free!
  www.TeamViewer.com/Remote_Control

Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.

When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.

Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!