I have had to re-install a windshield wiper motor in a 1981 Chrysler New Yorker. Upon completion the motor seems to either lock up or not be in the same sequence/rotation as the wiper arms. How can I get the motor and arms in sequence/rythym?

Hello. Simply remove the 'windshield wiper' fuse. It seems your windshield wiper motor is 'hard wired'; comes on when you turn on the ignition switch. That's not good!

REMOVAL

1. Raise and support the hood.
2. Remove the windshield wiper pivot arms.
3. Remove the cowl top vent panels.

1. Disconnect the windshield wiper mounting arm and pivot shaft.

1. Remove the access cover from the dash panel.
2. Remove the mounting arm and pivot shaft retaining clip.
3. Disconnect the windshield wiper mounting arm and pivot shaft from the windshield wiper motor.

1. Remove the windshield wiper motor.

1. Disconnect the electrical connector.
2. Remove the three bolts.
3. Remove the windshield wiper motor.

INSTALLATION

1. Install the mounting arm and pivot shaft retaining clip on the windshield wiper mounting arm and pivot shaft.

1. Install the windshield wiper motor.

1. Place the windshield wiper motor in the dash panel.
2. Install the three retaining bolts.
3. Reconnect the electrical connector.

1. Reconnect the windshield wiper mounting arm and pivot shaft.

1. Press on the windshield wiper mounting arm and pivot shaft after it is aligned with the windshield wiper motor.
2. Install the access cover in the dash panel.

1. Install the cowl top vent panels.
2. Install the windshield wiper pivot arms.
3. Adjust the windshield wiper pivot arms.

This is technically for the V6 4.2L but I'm sure those Ford E250's have the same setup for windshield wiper motor. Let me know how it goes.

The wiper motor is located under the wiper cowling. You will have to remove the wiper arms and unscrew the screws holding the cowling in place and remove it to access the motor

there is 2 wiper motors . 1 for the drivres side and the other for the passenger. sounds like a bad passenger side motor

if you want to remove the wiper arm, just move your wiper arms in standing position and remove the wiper nut cover. there you can now see the nut that is holding your wiper arm.

if you want to remove the whole wiper assembly, just remove the wiper assembly cover, from there you can already see the nuts and bolts to be removed.

Anytime the windshield wiper blades do not park themselves normally, the windshield wiper motor should be replaced.

My wipers wouldn't work and I found out that you need to get a new shift for the windshield wipers. It worked for me. Hope it helps

Yes you will likely need a new cluster. Try a salvage yard or ebay. Check to see if the wiper arm is stripped or for a loose attaching nut. Try oiling the slides of the windows with silicon spray lubricant.

go to your wipper motor under the shroud infront of wind shield and look for a metal plate at the botom there is a bolt threw it clean it up on both sides that is your ground.

nothing else holding it
with nut removed lift wiper to lock out and then just rock the base side to side and thats it off it comes