- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
NOTE: The following procedure may vary a bit from the system which you have in your car.
TO REMOVE RADIO RECEIVER ASSEMBLY
(a) for Integrated with Panel:
(1) Disconnect the hazard warning signal switch
connector.
(2) Remove the 4 bolts.
(3) Disengage the 4 clips and the 4 claws and
remove the radio receiver.
(4) Disconnect the plug.
(5) Disconnect the 3 radio connectors.
(b) except Integrated with Panel:
(1) Remove the 4 bolts and the radio receiver.
(2) Disconnect the plug.
(3) Disconnect the 2 radio connectors.
1. REMOVE INSTRUMENT PANEL CENTER REGISTER
ASSEMBLY (for Integrated with Panel)
2. REMOVE RADIO BRACKET RH
(a) for Integrated with Panel:
(1) Remove the 4 screws and the radio bracket.
(b) except Integrated with Panel:
(1) Remove the 4 screws and the radio bracket.
3. REMOVE RADIO BRACKET LH
HINT:
Use the same procedure as for the RH side.
the bulb might be out on the service light in which case you will have to remove the cluster and replace the blub. a/c you will have to go to a shop to get looked at. most likely you have a leak somewhere in the system
×